The wire/s probably grounded or short circuited by touching each other or metal nearby. If there is a fuse check to see if it's blown. If so replace it. If there isn't a fuse (which is usually the case) the transformer will have to be replaced by a qualified person. An in-line fuse holder with the correctly rated fuse (and a couple of spares)would be a smart and cheap addition to protect the transformer from future shorts.
The spring should be towards the motor. A very few are not round and have to be in the correct position which is obvious. As long as the plate in the middle of the thermostat is round, it can be in any position.
You have to install the thermostat with the jiggle valve in the 12 o'clock position.
Yes, the key must be in the position ON, but do not crank.
To turn on the thermostat in your home, locate the power switch or button on the thermostat and set it to the "on" position. Then, adjust the temperature setting to your desired level.
To turn off the thermostat in your home, locate the power switch or button on the thermostat and simply switch it to the "off" position. This will stop the thermostat from controlling the temperature in your home.
Thermostat is most likely stuck in the open position; replace the thermostat.
To turn off the thermostat, locate the power switch or button on the device and switch it to the "off" position. This will stop the thermostat from controlling the temperature in your home.
If the fan doesn't come on even if set in the on position, this is an indication that no current is getting to the furnace. If it comes on if the thermostat is as low as it can go, then it could be a faulty thermostat.
The circuit breaker may be stuck in the middle position due to a malfunction or overload in the electrical system, preventing it from fully resetting or tripping.
show picture of position of thermodtst in engine
i need see picture position on thermostat
On the left hand side of the engine is the thermostat housing. The camshaft position sensor is located directly above the thermostat housing on the end of the cylinder head.