Either raise the floor or un-solder the flange and lower it
Soldered joints will have a higher resistance if the joint is not a clean solder joint. Badly soldered joints are classed as a cold solder joint. <<>> ...for what? Application matters here.
It is very weird and I am gonna help. Zinc and copper create a higher voltage than copper and copper because zinc has a higher voltage than copper so copper plus zinc equals more than copper plus copper.
Copper has a higher heat capacity than styrofoam. This means that copper can absorb more heat before its temperature increases compared to styrofoam.
castings made from copper alloy are a higher grade of copper than the copper in wire. Also, the insulation on the copper wire needs to be removed,
No, aluminum has a higher resistance than copper.
Nickel cannot replace copper in copper II sulfate because nickel is higher in the electromotive series than copper.
To give a higher surface area for the reaction
A thicker copper wire will have higher resistance as it will offer more opposition to the flow of electrons compared to a thinner wire. Additionally, a longer copper wire will have higher resistance compared to a shorter wire due to increased distance for the electrons to travel. Finally, a copper wire with impurities or defects will have higher resistance than a pure copper wire.
When zinc is dipped in a copper sulfate solution, zinc will undergo a single displacement reaction where it will replace copper in the solution to form zinc sulfate and copper. This is because zinc is higher on the activity series than copper, so it is able to displace copper in the solution.
Copper
Copper has a much higher thermal conductivity compared to cotton wool, so copper would have a higher U value. Thermal conductivity is a measure of how easily heat passes through a material, with higher values indicating better heat conduction. Cotton wool, being a less conductive material, would have a lower U value.
Depends on how much higher and how the toilet is made. They are not all the same. A PVC flange is supposed to be above the floor level and will clear. They are about 1/4 inch thick. You can probably get away with up to 3/8 of an inch, but any more than that and the toilet will rock on the drain and eventually leak.