0
What else can I help you with?
Can you connect brass to copper pipe?
Yes, you can either solder them or fit mechanical (threaded) fittings.
How do you solder copper to brass fittings?
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Can you solder a brass fitting to copper?
Certainly look up Flagg Flow T.P Fittings T.P thread-less copper fittings will FIT on schedule 40/80 /120 Brass pipe Ideally it should be brazed but soldering will hold domestic water pressures Also many solder fittings ARE CAST BRASS rather then wrought copper
Should you solder or braise brass water fittings?
Always and only solder.
How do you solder electric wires to a brass fitting?
*Yes you can solder brass, as long as it isn't the decorative polished brass. They have used brass fittings in plumbing for years and years. It has the same characteristics as copper.
Can you solder brass to copper?
Yes, brass can be soldered to copper using a soldering iron and appropriate soldering techniques.
Can pure brass be soldered using plumbing solder?
No, pure brass is difficult to solder with plumbing solder because it has a high melting point and poor wettability with typical lead-based solders. It is recommended to use an appropriate flux and solder with a higher silver content for better adhesion and conductivity when soldering pure brass.
What is the best way to replace plumbing fittings?
For basic plumbing fittings, either copper or brass fittings is your best bet. Copper is more for just water lines, and brass is for various uses, but more expensive. Sites like DrillSpot.com are great places to start looking.
Is Teflon tape always necessary on threaded brass fittings?
Teflon tape is not always necessary on threaded brass fittings, but it can be beneficial. It helps create a watertight seal and prevents leaks, especially in plumbing applications. However, if the fittings are designed for a tight fit and are adequately tightened, they may seal effectively without tape. Always consult the manufacturer's guidelines for specific recommendations.
Is it ok to connect PVC to brass fittings?
Yes, as long as there is a mechanical connection , ie threaded. You cannot glue them to each other.
What 5 metals are in amalgom brass and solder?
Brass is an alloy of Copper and Zinc. Originally solder is an alloy of Tin and Lead. Lead-free solders in commercial use may contain tin, copper, silver, bismuth, indium, zinc, antimony, and traces of other metals.
What is the working pressure for red brass schedule 80 threaded pipe?
That would depend on the temperature "Temperature pressure relationship" and the fittings used
