Certainly look up Flagg Flow T.P Fittings
T.P thread-less copper fittings will FIT on schedule 40/80 /120 Brass pipe Ideally it should be brazed but soldering will hold domestic water pressures
Also many solder fittings ARE CAST BRASS rather then wrought copper
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Yes
*Yes you can solder brass, as long as it isn't the decorative polished brass. They have used brass fittings in plumbing for years and years. It has the same characteristics as copper.
Sure why not
Yes, brass can be soldered to copper using a soldering iron and appropriate soldering techniques.
1st you need to know where the leak is. The only time a copper fitting or brass fitting will fix a leak is in the watersupply connection.
No, pure brass is difficult to solder with plumbing solder because it has a high melting point and poor wettability with typical lead-based solders. It is recommended to use an appropriate flux and solder with a higher silver content for better adhesion and conductivity when soldering pure brass.
It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.
You cannot solder Steel BUT you can braze steel and copper and you can thread steel and then use a copper x female adapter Or finf a steel fitting and use a C x M adapter
Yes, you can either solder them or fit mechanical (threaded) fittings.
To properly solder a copper pipe, first clean the pipe and fitting with emery cloth. Apply flux to both the pipe and fitting, then heat the joint with a propane torch. Once the joint is hot enough, touch the solder to the joint and let it flow around the connection. Allow the joint to cool and wipe away any excess solder.
In order to connect a chromed steel pipe to a copper pipe, you will need a brass fitting. These two pipes will not fit into each other otherwise.