answersLogoWhite

0

What else can I help you with?

Related Questions

What fitting is required to join copper with galvanized pipe?

A threaded copper fitting on the copper side, male or female, and the galvanized is screwed into it.


Is a soldered fitting better then a threaded fitting?

Depends on what you are doing. soldered is for copper water lines. Threaded can be for water, gas, or anything else.


How do you solder copper to brass fittings?

Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.


Can you connect brass to copper pipe?

Yes, you can either solder them or fit mechanical (threaded) fittings.


What is a sweat inlet?

It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.


How do you solder steel and copper?

You cannot solder Steel BUT you can braze steel and copper and you can thread steel and then use a copper x female adapter Or finf a steel fitting and use a C x M adapter


How do you properly solder a copper pipe?

To properly solder a copper pipe, first clean the pipe and fitting with emery cloth. Apply flux to both the pipe and fitting, then heat the joint with a propane torch. Once the joint is hot enough, touch the solder to the joint and let it flow around the connection. Allow the joint to cool and wipe away any excess solder.


Should you use a brass threaded male fitting to a PVC threaded female fitting?

no


Galvanised pipe to copper pipe fitting?

You will want to put a length of copper into the fitting and solder it before you put it on the galvanised so that you don't cook out the pipe dope. >>they also could have soldiered on a flange on copper and thread on galvanized pipe.would have been another choice


You want to replace old lead pipe connected to cast iron sewer pipe with copper How do you connect the copper pipe to the old lead pipe or to the cast iron pipe?

When I have to connect copper to lead "D" I usually solder the copper to the lead or wipe a lead joint depending on the diameter To connect copper to cast iron ,.... If there is a hub I caulk the copper directly into the CI with oakum and poured lead (molten) OR one can solder / braze a female adapter fitting and screw the copper into a CI female fitting


Can you solder a brass fitting to copper?

Certainly look up Flagg Flow T.P Fittings T.P thread-less copper fittings will FIT on schedule 40/80 /120 Brass pipe Ideally it should be brazed but soldering will hold domestic water pressures Also many solder fittings ARE CAST BRASS rather then wrought copper


How do you solder a copper pipe end?

Clean the end of the pipe and whatever kind of fitting you are putting on it with either steel wool or fine sandpaper. Put flux on both pieces covering all the surface where they will be joined. Use a propane torch and heat on one side of the fitting and touch the solder on the opposite side. When the solder gets hot enough to melt, it will be drawn to the heat source. By having the solder on the opposite side from the heat you know there is solder completely around the fitting. Let it cool before handling.