With a manufacturers leak repair kit normally supplied as an add on device
1st you need to know where the leak is. The only time a copper fitting or brass fitting will fix a leak is in the watersupply connection.
Water may be leaking from your dishwasher due to a damaged door seal, a clogged drain hose, a faulty water inlet valve, or a cracked or loose water supply line. It is important to identify and fix the source of the leak to prevent further damage to your dishwasher and surrounding area.
if the leak is at the thermostat housing, make sure you installed the gasket and that is torque down to specs.(you may try some silicone,not too much)
Your dishwasher may not be draining properly due to a clogged filter. To fix this, you can remove the filter from the dishwasher and clean it thoroughly. This should help improve drainage and ensure your dishwasher functions properly.
call a repair man
I have a waterline leak at my home from the street to my home....can I get a grant to fix this leak?
What kind of leak and where is it?
Take it to a garage. It can leak at several places and there are seals that can be installed to stop the leaks.
That depends on where the leak is coming from. If it's from a hose than replace the hose. If it would be from the rad, you could always apply silicone to the crack in the rad or purchase a new rad and have it installed.
Stop leak is a temporary fix. I don't recommend it. Tighten the clamps on the hoses going into the raditor.
You will have to locate the source of the leak before you can fix it. Re-post with your findings.
You have to determine the source of the leak then decide on how to fix it.