it's called stop holding down the flusher.
Your toilet may be leaking when flushed due to a faulty flapper valve, a loose or damaged fill valve, a cracked tank or bowl, or a worn-out wax ring. These issues can cause water to escape from the toilet and create a leak. It is important to identify and fix the problem to prevent water waste and potential damage to your bathroom.
think the drain may be slightly blocked. Your best bet is to call a plumber now to fix it. If you leave it too long you may have toilet water coming up in other areas in your house. You can try to fix it yourself but most of the chemical treatments don't do a lot.
Run a new cold supply line from the source. This will drain less pressure from the the cold shower line.
If there is a loud noise coming from the upstairs toilet when it is flushed, it could be a sign of a plumbing issue like a clog or a problem with the water pressure. It is best to contact a plumber to inspect and fix the problem to prevent any further damage.
A running toilet is usually caused by a faulty flapper or fill valve, which can lead to water continuously leaking into the bowl. This can waste water and increase your water bill. It is important to fix the issue promptly to prevent further water waste.
Your toilet may be gurgling when flushed due to a clog in the drain pipe, a blocked vent pipe, or a malfunctioning fill valve. This can cause air to be trapped in the pipes, leading to the gurgling sound. It is recommended to have a plumber inspect and fix the issue to prevent further problems.
To adjust the toilet float to fix a running toilet, locate the float mechanism in the toilet tank and adjust the float arm or screw to lower the water level. This will help stop the water from continuously running.
To fix a leak of water coming from the base of your toilet, you can try tightening the bolts at the base of the toilet, replacing the wax ring seal, or contacting a plumber for assistance.
Someone installed the plumbing wrong. Instead of the water going down into the main lead, it's taking the other toilets route and flooding over, an easy fix unless you have to tear up the floor.
What you probably need to do is snake out the vents. You probably have debris in them.1- you may have a slight blockage2- Poor venting and water Jetting will scour the piping rather then rodding
If your toilet fill valve is leaking, you may notice water constantly running into the toilet bowl. To fix it, you can try adjusting the valve or replacing it with a new one.
Probably leaky drain pipe form toilet which passes through that room. Work out which corner of that room is below the toilet, you will probably see a swelling in the wall where the drain pipe is hidden. Call a plumber and get him to fix it.