answersLogoWhite

0

The saddle is PVC and held on with two U bolts. Put the clamp in position, on the top side if putting it on a horizontal pipe. Mark around on the inside of the hole in the saddle. Use a new 1/8th drill bit you might need several, and make a series of holes almost connecting around the hole you marked. When you have them all drilled, elongate them to connect them, When most of them are connected tap on the plug until it begins to break out. Try and catch it before it falls into the pipe. You can drill 1 hole in the center and put a screw in it to hold onto. Put a bead of plumber putty around the hole where the saddle will compress it. Put the U bolts on and tighten.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you install a cast iron shower drain on 2 PVC?

With a compression mission ring


Install sink drain into cast iron pipe in basement floor?

Yes, it is done all the time


How can you cut into your main drain to branch off for another bathroom downstairs?

Downstairs? First floor with a basement or in the basement? If first floor with access in the basement or crawlspace, no real problem. PVC, just cut the pipe and install a T. Cast iron, you can use a Saddle Clamp made for this. Looks like a PVC T split length wise and held to the cast iron with two U bolts. If adding a bath in the basement, you will have to bust out the floor, add the drain and replace the cement.


What is the cost to replace a cast iron drain pipe?

The cost to replace a cast iron drain pipe can vary depending on factors such as the length of the pipe, the complexity of the installation, and the location of the pipe. On average, homeowners can expect to pay between 1,500 to 3,000 for a professional to replace a cast iron drain pipe.


Cast iron floor drain from Saudi Arabia?

Where? What is your question?


How do you tap into cast iron drain pipe for a new shower drain in basement?

By cutting in a cast iron Wye so the flow enters the sewer line (soil pipe) at a right angle


What is the direction of flow in a cast iron hub and spigot drain pipe?

from the hub to the spigot


What kind of plumbing pipes were used in 1955?

Galvanized pipe for water and drain lines. Cast iron pipe for main drain lines.


How do you replace drain in cast iron tub?

You remove the existing tub shoe and related fittings and install a new assembly. In some cases a reciprocating saw will be needed to cut the shoe flange located inside the tub


Is it a roofing issue or plumbing issue roof drain dripping?

Both and but normally a master plumber would fix the problem by removing the existing drain lead/copper /cast iron and install a new drain and remove the membrane to the existing slab water proof the slab with either roof cement or flashing cement then install 4 PSF sheet lead over the drain flange/clamping gravel stop collar and you will now have a leak proof job


How do you repair rusted out at foundation cast iron drain pipe?

If it is "rusted out" you do not repair it, You do replace it with XHCI


Can you attach PVC piping to a cast iron toilet drain?

Yes, but PVC creates problems