answersLogoWhite

0

What is actually broken the flnge ring rusted out and broke or the abs pipe? Abs pipe/flange broken: Use a ram bit to cut it out and install a new one. http://www.plumbingsupply.com/pvcsaver.html use a compression or expansion flange http://www.plumbingsupply.com/toiletflanges.html or just cut the pipe and put in a new one Flange ring rusted/broken: install a toilet flange repair ring or a spanner flange.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What is an offset closet flange?

It offsets the floor flange bolts by 2"


What is flange adapter?

The flange adapter is a part that is used to adjust the size to the next piece so it will connect. It can be made out of any material.


What flange adapter?

The flange adapter is a part that is used to adjust the size to the next piece so it will connect. It can be made out of any material.


Does a wax ring seal the bottom of the water closet to the closet flange?

Yes.


How can I replace a toilet closet flange?

To replace a toilet closet flange, you will need to remove the toilet, unscrew the old flange, clean the area, install a new flange, and reattach the toilet securely. Make sure the new flange is level and properly sealed to prevent leaks.


Should the closet flange be set on top of a tile floor?

Closet flanges should always have the bottom of the flange resting on top of the finished floor. So to answer this specific question, the tile should be under the flange and the flange should be secured to the subfloor.


How do you remove the broken closet flange from a cast iron drain pipe?

I removed the broken flange by perforating the lead filling between the drain pipe and the flange - i.e., drilling holes every 1/4-1/2 inch or so with a regular drill and then sawing through the filling with a power saber saw. Then pried the flange off with a pry bar. Wasn't as bad as I expected. - Dan


What is the purpose of a closet flange in a plumbing system?

The purpose of a closet flange in a plumbing system is to securely connect a toilet to the floor and the waste pipe, providing a stable and leak-proof seal.


Should you glue your toilet closet flange to your pipe?

No, it is not recommended to glue the toilet closet flange to the pipe. The flange should be secured to the floor using bolts or screws, and the toilet is then secured to the flange using wax rings or sealing gaskets. Gluing the flange to the pipe can make it difficult to remove or replace the toilet in the future.


How do you fix a slightly loose toilet that is seated on ceramic tile?

Pull the toilet. Check the closet flange. If it is not loose or broken, replace the wax ring and closet bolts. Reset toilet. Level with wobble wedges. Caulk base of toilet.


What do you do about a very rotted cast iron closet flange that is cemented to the 3 inch DWS pipe?

If it were mine I would chip out the concrete down to the point where the pipe is solid then I would install a new closet flange.


How can I fix a broken toilet flange?

To fix a broken toilet flange, you can start by removing the toilet and old flange. Then, install a new flange by securing it to the floor with screws. Make sure the flange is level and properly sealed. Finally, reattach the toilet and test for leaks.