0
If you mean the joint at the bottom of the sink drain that curves up and hooks to the pipe leading through the wall, it is called a "P" trap (due to its shape). The trap is held in place by two nuts, one attaches it to the sink drain and the other attaches it to the drain pipe leading outside. Loosen the two nuts to disconnect the trap and pull down on it. Have a bucket handy as it will have water in it and will spill. If you have a problem with slow drainage, you might want to run a snake through the drain pipe while the trap is off. Installation is the reverse, be sure to use Teflon tape or other kind of thread sealer to prevent leakage through the threads.
What else can I help you with?
What is the purpose of a garbage disposal elbow in a kitchen sink plumbing system?
The purpose of a garbage disposal elbow in a kitchen sink plumbing system is to connect the garbage disposal unit to the drain pipe, allowing food waste to be efficiently and safely disposed of down the drain.
Whatisthe best way to remove thermostatin 1977 Cutlass Supreme there is an elbow pipe holding it in place?
That elbow pipe ( thermostat housing ) has 2 bolts in it, take them out and remove the housing ( you may have to tap it with a rubber mallet) be sure to have a new gasket ready and remove all traces of the old one before reassembly.
Is an elbow pipe geometry?
No, it is a pipe! (with apologies to Magritte!)
What is the purpose of the vent hood exhaust pipe in a kitchen?
The purpose of the vent hood exhaust pipe in a kitchen is to remove smoke, steam, grease, and odors from cooking and improve air quality by venting them outside the building.
How can I effectively repair a kitchen sink drain pipe?
To effectively repair a kitchen sink drain pipe, start by identifying the issue, such as a leak or clog. Next, turn off the water supply and remove any obstructions. Use a pipe wrench to loosen and remove the damaged section of the pipe. Replace it with a new section of pipe and secure it with pipe fittings. Finally, test the repair by running water through the sink to ensure there are no leaks.
What is the best way to clean a pipe using a pipe cleaner brush?
The best way to clean a pipe using a pipe cleaner brush is to insert the brush into the pipe and move it back and forth to scrub away any residue or buildup. Repeat this process until the pipe is clean, then rinse it with water to remove any remaining debris.
Formula on how to fabricate 16 inch pipe elbow?
elbow senter making
How do you remove brass clean out plug on black plumbing?
With a very large pipe wrench !
How do you remove fuel filter on a 91 Plymouth laser?
. Disconnect and remove the battery and the battery box. Remove the upper IC pipe (If turbo'd) and throttle body elbow. Now you can see the fuel filter
Can the vent pipe for the toilet have an elbow in it?
Yes.
What is the answer to level 41 for fill the pot in logic game box?
Put the pot under the main piping and simply put a horizontal pipe, elbow, vertical pipe, elbow, horizontal pipe.
Do you have a formula for pipe cut piece to 90 degree elbow?
Yes, to calculate the length of pipe needed for a 90-degree elbow, you can use the formula: Length = (Distance from the center of the elbow to the center of the next fitting) - (Radius of the elbow). The radius is typically specified by the elbow type (e.g., short or long radius). Additionally, consider any allowances for fitting tolerances when cutting the pipe.
