To use the set button on the ts-rc411 remote control, first ensure the device you want to program is powered on. Press and hold the "Set" button until the indicator light turns on, then release the button. Next, press the corresponding device button (like TV or DVD) for the device you want to control, and the indicator light will blink and turn off. Finally, enter the appropriate code for your device, and if successful, the indicator light will turn off; if not, repeat the process with a different code.
Turn the radio on and press the Set button. When the "P" displays, press the Sel button. Use the tuner dial to set the hour. Then, press the Sel button again and use the tuner dial again to set the minutes. Press the Sel button once more and the time is saved!
Adjust radio to desired stationPress set button twicePress pre-set button desired for that station.
turn the radio off and press the set button use the seek button to adjust the time
Hold time button until hour flashes, use audio button to adjust hour,push in audio buttonand minute will flash use audio button to adjust minutes then when time is set push in on audio button again and time is set.
hold the "rcl" button in and use the "seek" button for hours and the "scan" button for minutes
vvTurn your ignition to Acc, turn off your radio, hit the set button, use your seek button for hours and your scan button for seconds, once you set the time hit set again to save changes.
Turn the radio on. Press SET button. This puts the radio in (Program) mode. Press SEL button, then use the up and down on tune to set the hour, then press SEL and use tune to set the minutes.
On my 1995 XLT the instructions are - with the radio on - PRESS AND HOLD THE "CLK" button and use the SEEK button to increase or decrease the HOURS , and use the TUNE OR TUNE DISCS button to increase or decrease the MINUTES After time is set - release the "CLK" button
hold clock button and use the seek or other button underneath while holding the clock button
Press and hold the " CLK " button To adjust the hours use the " SEEK " button To adjust the minutes use the " TUNE or TUNE DISC " button
To set a 4-button countdown clock, first, press the "Set" button to enter the time-setting mode. Use the "+" and "-" buttons to adjust the hours and minutes as needed, confirming each setting with the "Set" button. Once the desired time is set, press the "Start" button to begin the countdown. If needed, you can pause or reset the timer using the appropriate buttons.
To set the day on a digital W Cardinal watch, first, press and hold the "Mode" button until the display starts flashing. Use the "Adjust" or "Set" button to navigate to the day setting, then press the "Mode" button again to select it. Use the "Adjust" button to change the day, and finally, press the "Mode" button to save your settings and exit.