About 10 minutes if they know what they are doing
Drain under the sink or main to the city sewer? It depends on how long a plumber is there. $50 to $250.
This depends on whether it is a sewer drain or a storm water drain. Depends how long it will take the plumber to clear the drain. Depends whether the plumber uses plumbing rods or a high pressure machine to clear the blockage. Depends on the plumbers rate, you get some plumbers who charge cheaply and others who make you sell your kidneys so you can pay their fees.
Depends on how long your drain line is and where the stoppage is. You could rent a drain snake from a hardware store but if you don't know how to operate one I would suggest you call a plumber or roto rooter man (look in the yellow pages).
5 years for a normal plumber and 7 years for master plumber and yearly after you get you master plumber certificate
This depends on what material the plumber uses, what fittings the plumber uses, how much piping will be used and how long the plumber will take.
Yes as long as the drain has a trap and is vented
the only thing i can think of is an outside faucet bib is cracked . .i have been in the service end and the maintenance end of buildings and home repairs for a long time and the only instance i came across was a washing machine's drain pipe was cracked from the cold and in the spring timethe drain pipe keaked in the ground outside of the garage causing water and soapy water at that to run down the driveway.
I have a clog somewhere in my sewer system. A friend told me about a thing they do called a sewer camera inspection where they get a long snake and run it up to find the clog. Can any old plumber do this service or do I need to find someone special? Is it expensive?
Well there are many ways you can repair or fix your clogged sink. One is to by a snake it is like this long tube you can stick down the the drain of the clogged sink and pull the gunk right on up. There is also another solution you can easily buy liquid plumber. Then there is the simple method the plunger.
If you can't find a drain plug, then just drain from the lower hose. Its long, and goes to the other side of the engine. This will work.
Plumber's putty typically takes around 24 hours to fully dry and set.
A drain snake is a device used to unclog drains. A drain snake has a long, flexible metal cable, with a corkskrew auger or blades attached to the end, and is rotated in a downward spiral into a drain until it reaches a clog, then the corkscrew auger ideally displaces the clog as if "chewing" away at it.