0
What else can I help you with?
How much water is used to fill a washing up bowl?
LOLOLOLOLOLOLOLOL
How can I fully drain a toilet?
To fully drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. Finally, use a wet/dry vacuum to suction out any remaining water in the bowl and tank.
How can I fix the issue of too much water in the toilet bowl?
To fix the issue of too much water in the toilet bowl, you can try adjusting the water level in the tank by adjusting the float or flapper. You can also check for any clogs in the toilet's drain or vent pipes. If these steps don't work, you may need to call a plumber to further diagnose and fix the issue.
How can I completely drain a toilet?
To completely drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. You can also use a wet/dry vacuum to suction out any remaining water.
How much is the toilet cistern cost can it be DIY?
Toilet cistern can cost a lot since it is the most used water in the house. But there is some ways to reducing the amount of water your toilet is flushing. First fill a half gallon container with water, place the container in the tank of the toilet, lower it in to the water, replace the lid and then youÕre ready to flush.
How do you increase suction in older toilet?
Toilets do not function on suction, they flush by using gravity to empty the water from the tank into the bowl, thereby causing the S-trap built into the toilet bowl to siphon. The only way to improve the flush is to cause it to flush with more water (which sometimes helps, sometimes doesn't), or buy a siphon-jet or other power assisted toilet. An older toilet may be to plugged up with mineral deposits to improve the flush much, the amount of deposit depends on what's in your water, how often you clean the toilet, and other factors beyond your control.
How many times do hamsters have to be fed?
If you have a bowl for your hamster, and a cage, all you have to do is fill up the bowl and the water cup and the hamster is smart enough to know howe much to eat. When the bowl is emptty, refill or else he/she will starve.
What should you do if there is not much water in your toilet bowl and you tried flushing it again and the plunger isn't working?
Time to give up and call a plumber to clean your drain line.
What is as round as a bowl deep as a tub but all the world's water couldn't fill you up what are you?
The answer to the riddle is a sieve. A sieve is round and can be deep like a tub, but its numerous holes mean that it can't hold water, regardless of how much is poured into it. Thus, no matter how much water you try to fill it with, it will never be full.
How do you allow less water to get in the toilet bowl?
If you want to use less water per flush, you put a brick in the bottom of the tank. You do not want to reduce the height of the water in the tank so much as use less water per flush.
Is there a way to get scratches out of the inside bowl of a toilet?
yes, you can have your toilet refinished. Another option is to buy some porcoline patch and do it yourself. Just shut off your angle valve and drain as much water as you can out of the bowl by holding down the trip lever. The water should go down enough for you to repair the scratches and let it dry before turning the water back on. Refinishing the bowl is expensive and unecessary. A little "Soft Scrub" and alot of elbow grease will usually do it.
What can cause a commode not to flush?
Clogged toilet, mainline stoppage, not enough water in the tank or bowl, too much slack in flapper chain, bad flapper, broken handle...
