i need to see a pic of your problem before answering
To remove the plastic cover of the door lock on a 1997 Ford Fiesta, you typically need to gently pry it off using a flathead screwdriver or a trim removal tool. Be careful not to break the plastic clips holding the cover in place. Once the cover is removed, you can access the lock mechanism underneath.
the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side
10 years or 100,000 miles
if the clock doesn't work then change the clock
the horn is in the drivers side wheel well. u have to remove the plastic cover and it should b right there
the plastic cover should pop right off exposing the bulbs
Sounds too complicated to even suggest. I tried to do mine 2 weeks ago and it cost me more time and money to get the job repaired. I used a specialit car locksmith in the end called The Auto Locksmith www.theautolocksmith.co.uk Maybe you are better then me and can repair a faulty fiesta lock yourself. www.theautolocksmith.co.uk/DamagedLocks.html Good luck
where can i find the temperture sensor on a ford fiesta 1997
Its inside the passenger side front fender. Remove the plastic cover. Replace as you would any other Lincoln filter.
In trunk on right hand side, under plastic cover.
There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.
On a 1997 Ford Ranger : Open the drivers door , and IN the end of the dash you will see a removable plastic fuse panel cover ( the fuses are behind the cover )