yes
there no anteena num nuts
dipole antennas evolved antennas ground anteena
d is 304m ali bellaghma algeria bellaghma-ali@live.fr
because AC(alternating current) either uses 50Hz/60Hz.and for such a low frequency anteena at Recieving end becomes of infinite length Or say uncontroleable.if so we can use modulation technique,can use carrier of high frequency which will definitly reduces anteena size then why this way of transmitting electricity has adopted yet?
When an antennae is not able to pick up a clear, strong signal then it needs help. A gain will boost the signal and allow you to receive a good signal
brown wire is called earth wire .or blue wire with white stripe is for anteena wire ok
Actually the customers of the satellite phones do face problems like of heavy clouds, monitoring bases, improper connections, anteena probles and many more.... .
directors and receivers are the main part of a yagi uda anteena there can be many directors and receivers as more receivers will surely increase our gain but we use only one receiver because the gain will not increase much but the cost will surel increase
A butterfly antenna is a pair of sensory organs located on the head of a butterfly. These antennas are used to detect environmental cues such as smells, sounds, and even air vibrations. They play a crucial role in the butterfly's ability to navigate, find food, and communicate with others.
No they have to offer the local channels along with their basic cable package. You otherwise don't need cable and buy an anteena instead for the local channels.
A thin wire antenna, such as a dipole or monopole, is a simple and efficient antenna design that is often used for receiving or transmitting radio signals. The current distribution on a thin wire antenna is non-uniform and varies along the length of the wire. At the center (feedpoint) of the antenna, the current is typically at its maximum, decreasing towards the ends. This current distribution creates a radiation pattern that determines the directionality and gain of the antenna.
1. Remove the cover that holds the antenna.This is located outside the antenna.No need to go inside your trunk. There will be two little holes on top of the cover plate.(I am sure there is an special tool that Infintany would like you to buy). I used Spark plug pliers.Because they are rubber coated.You really want a tool that protects you paint. 2. Remove the antenna. Installation. 3. slide the base and the cover over the antenna. 4.Have someone in the car.Turn the radio on.So the the motor full extends the anteena. Do not screw the base down at this time. 5.Put the gear into the motor.Have the person in the car turn off the radio.This will bring the gear into the motor.NOTE. You may have to do this a couple of times so that the gears catch. 6. Once the antenna is fully stowed..Srew the base down. 7.Turn the radio back on.If you see that the antenna does not fully extend. Just pull it up by hand. I recomend that you buy the 4 inch antenna.It just looks better.It cost a little more.