1. Remove the cover that holds the antenna.This is located outside the antenna.No need to go inside your trunk. There will be two little holes on top of the cover plate.(I am sure there is an special tool that Infintany would like you to buy). I used Spark plug pliers.Because they are rubber coated.You really want a tool that protects you paint. 2. Remove the antenna. Installation. 3. slide the base and the cover over the antenna. 4.Have someone in the car.Turn the radio on.So the the motor full extends the anteena. Do not screw the base down at this time. 5.Put the gear into the motor.Have the person in the car turn off the radio.This will bring the gear into the motor.NOTE. You may have to do this a couple of times so that the gears catch. 6. Once the antenna is fully stowed..Srew the base down. 7.Turn the radio back on.If you see that the antenna does not fully extend. Just pull it up by hand. I recomend that you buy the 4 inch antenna.It just looks better.It cost a little more.
how do I replace a power antenna on my jeep Cherokee 1992
To replace the power antenna shaft on a 2001 Firebird, first, remove the interior trim panel around the antenna to access the assembly. Disconnect the power connector and unscrew the antenna from its mounting point. Then, pull the broken shaft out and insert the new one, ensuring it is properly aligned. Reassemble the antenna, reconnect the power, and test it to ensure proper operation.
how do you replace power antenna on 1988 deville
To replace the power antenna on an Infiniti I30, first, disconnect the negative battery terminal to ensure safety. Remove the interior trim panel to access the antenna assembly, then disconnect any electrical connectors and unscrew the antenna from its mounting location. Install the new antenna by reversing the removal process, ensuring all connections are secure, and finally reconnect the battery. Test the antenna to confirm it operates correctly.
The plastic gear line is broken, you just replace the center section of your antenna.
need to know is it power and is just the mas broken if it is just the mas and its power it not a big deal it takes about 5 min.
Open up the truck.. Unplug power line but, don't unplug the antenna line. It's will be used for your remote. - brokenics@yahoo.com
I took out number 40 inside the car.
No
Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.
Replace the power antenna assembly.
Go on the Nicoclub.com site and search for power antena and there will be instructions. If your antena will not retract all of the way a piece of the plastic has broken off in the antena motor that has to be removed before you can place a new antena in it. Its easy to do.