answersLogoWhite

0

Did you flush out the valve body prior to installing the new cartridge

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Delta shower faucet leaks. replaced ball and seals still drips?

The ball very seldom is the problem it is the springs and cap washers


Why does the moen kitchen faucet still leak after replacing the cartridge?

If your Moen kitchen faucet continues to leak after replacing the cartridge, it could be due to several reasons. First, ensure the new cartridge was installed correctly and seated properly. Additionally, check for worn-out O-rings or seals that may also need replacement. Finally, inspect the faucet body for cracks or damage that could cause leaks.


When I close my single handle pullon pushoff sink faucet the water still runs so to actually shut off the water I need to open the faucet a little and turn it a bit?

The o rings inside the cartridge have become either faulty, worn or perished. You need to replace the cartridge for you to solve this problem.


Why does my faucet still run when it's turned off even after I changed the washer and O ring?

If it is a full stream, you put the cartridge in reversed. If it is just a drip, you may need to polish the bottom of the cartridge where it contacts the new cup. The metal plate on the cartridge can rust or have mineral build up on it. If it is the older style with a flat washer on the end of the stem, sometimes the seat the washer closes against can be pitted.


Does eljer faucet still honor your lifetime warranty on the sink faucet assembly purchaced in 1995?

They did in 2006.


Why is the faucet turned off but the water is still running?

The faucet may be turned off, but the water could still be running due to a leak in the plumbing system.


What would cause the cold side of a faucet to not turn off if you replaced the cartridge with the one from the hot and it still kept running?

Some cartrides are hot/cold specific. The hole that allows the water to pass thru the cartridge will not close because you can't turn it far enough. Some cartrides are hot/cold specific. The hole that allows the water to pass thru the cartridge will not close because you can't turn it far enough.


Can you disconnect the sprayer and still use the faucet?

If the sprayer hose screws onto the faucet, you can get a cap for that fitting. If it pushes into the faucet, I do not believe there is any plug available for that type. You have to have something on the hose fitting or water will come out when you turn the faucet on.


Do they still make 32 police ctg?

They still make a .32 caliber cartridge.


What should you do if your sinus drips down your throat you have taken anibiotics and gotten xrayed but nothing shows up of any concern but it still drips into your throat?

Maybe you should ask your doctor for a referral to a sinus expert.


I completely close my shower faucet but the cold water still runs it is a two tap faucet and it is just a shower not a shower bath combination what is going on?

Proably the faucet has a worn out washer, replacing the washer should fix the problem.


Why is Printing Ink Cartridge saying empty if I just changed it?

If you change the ink cartridge without letting the printer driver reset, it will think you are still using the old ink cartridge. Install the cartridge again using the "install new cartridge option". If you follow these directions you should not have a problem.