answersLogoWhite

0

Cover tape extenders are used when a reel of SMD components doesn't have a leader at the beginning of the reel. The tape extenders add an additional 508mm (20") of tape as a leader and feed into SMT placement equipment as a piece of cover tape. These tape extenders reduce the loss of components when you have no leader tape to work with. Can be used with either paper or plastic tape, punched or formed pockets, from 8-44mm width.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What were the main beliefs of federalists?

SMD SMD SMD SMD SMD


How might some groups of the declaration of independence in the future gain rights?

Smd smd smd smd smd smd


How might some groups use the declaration of rights in the future to gain rights?

Smd smd smd smd smd smd


What are the codes for Monster High code?

smd and smd


How do you rewind a steel fish tape?

To rewind a steel fish tape unscrew the cover. Gently lift the cover so that the steel tape does not come out. With time and patience, rewind the tape. Finally put the cover back on and screw it back in place.


What does smd stand for?

SMD stands for "Suck My D--k"SMD: Surface Mount Device


Can you replace electrical tape with duct tape to cover an exposed wire?

NO it is dangerous.


What does SMD in text language mean?

SMD means suck my dick


When was SMD high school created?

SMD high school was created in 1969.


How much tape in centimeters needed for 8 centimeters cube?

That depends on the width of the tape, and exactly what you're going to doto the cube with it.If you want to cover the cube with the tape, and the tape is ' W ' cm wide,then you need ( 512/W ) cm of tape to cover it completely.


How do you make a duct tape book cover?

the steps and the things you'll need will be at this site --> http://www.wikihow.com/Make-a-Duct-Tape-Book-Cover


How do you load tape into the Dymo Organizer 1610 labe maker?

To load tape into the Dymo Organizer 1610 label maker, open the tape compartment cover and insert the tape cartridge into the compartment. Make sure the tape feeds through the tape guide and closes the compartment cover. Then, turn the wheel to advance the tape until it is ready to print.