You must mean in DRAIN pipes. -It can not be used in plumbing pipes.
Of course they can
The presence of air in water pipes can reduce the efficiency of a plumbing system by causing airlocks, which can block the flow of water. This can lead to reduced water pressure, slow drainage, and potential damage to the pipes. Removing air from the pipes is important to maintain the functionality of the plumbing system.
Yes, air in water pipes can cause damage to the plumbing system by creating pressure fluctuations, leading to leaks, bursts, and other issues.
The presence of air in pipes can reduce the efficiency of a plumbing system by causing air pockets that block the flow of water, leading to reduced water pressure and potential clogs.
Potential causes of gurgling water in a plumbing system include air trapped in the pipes, clogs or blockages in the pipes, or issues with the sewer line.
To prevent sweating copper pipes when working on a plumbing project, you can insulate the pipes with foam pipe insulation or use a dehumidifier to reduce moisture in the air. This will help prevent condensation from forming on the pipes and causing them to sweat.
The pipes, tanks, faucets, and valves in a water system.
To prevent sweating copper pipes in your plumbing system, you can insulate the pipes with foam pipe insulation. This helps to reduce the temperature difference between the pipes and the surrounding air, preventing condensation and sweating.
The purpose of the plumbing vent on the side of the house is to allow air to enter the plumbing system, preventing air pressure buildup and ensuring proper drainage and flow of water through the pipes.
To effectively remove air from pipes in your plumbing system, you can start by turning off the water supply to the affected area. Next, open the highest and lowest faucets in your home to allow air to escape. You can also try using a plumbing snake or a plunger to help dislodge any trapped air. Finally, once the air is removed, turn the water supply back on and check for any remaining air pockets.
The term "sweating" in plumbing refers to the process of joining and sealing copper pipes and fittings by heating the copper and applying solder after the pipes/joint fitting have been properly cleaned and flux applied.