0
What else can I help you with?
Are drain rod sets of a universal fitting?
no
What is the name of the fitting that connects the P-Trap to the drain?
coupling
Where does the drain on a dishwasher go?
Garbage disposal, if one is installed, or a wye branch fitting on the tail piece of sink drain. Dishwasher drain line should have an air break or air gap before the disposal or wye branch fitting.
How can I effectively plumb a double sink?
To effectively plumb a double sink, you will need to install a double sink drain kit, which includes two drain pipes, a tee fitting, and a trap. Connect the drain pipes from each sink to the tee fitting, then connect the trap to the tee fitting and the main drain line. Make sure to secure all connections tightly and test for leaks before using the sinks.
How do you determine if the drain size is 4 or 3?
By the fixture units connected and the developed length of piping and fitting
How does a saddle drain work in plumbing systems?
A saddle drain is a type of fitting that is used to connect a smaller pipe to a larger pipe in a plumbing system. It is typically used to create a branch connection for a new fixture, such as a sink or a toilet. The saddle drain is installed by cutting a hole in the larger pipe, attaching the saddle fitting over the hole, and then connecting the smaller pipe to the fitting. This allows wastewater to flow from the new fixture into the main plumbing system.
How can you repair a leak that is visible on the side of your garbage disposal under your sink?
If the sink/sink drain fitting connection, sink drain fitting/disposal connection, dishwasher/disposal connection, disposal/drain elbow connection are what are leaking they can either be tightened or have gaskets replaced or other sealing methods used. If the disposal is leaking elsewhere the disposal needs replacement.
How do you drain the radiator coolant on a 1988 Mercury Topaz?
let engine cool -open radiator cap -move a large container under radiator drain fitting( it's hard to see- located on lower left corner of radiator)-attach 3/8" diameter hose to fitting to direct coolant into container- turn fitting counterclockwise-pliers may be needed.
Why is it called Hub and spigot drain pipe?
The Hub and Spigot are two types of fitting on either end of a pipe.At one end you have the Hub (Socket) fitting; which is a "female" end of a fitting designed to accept pipe or a SPIGOT connector.At the other end you have the Spigot fitting; which is a "male" end of a fitting designed to be used inside another fittings Socket (or Hub) end.
If my inflatable pool has a drain plug in the bottom can I attach a garden hose to drain water through?
If that will work then, yes. Most inflatables have no fittings that are compatible with a garden hose fitting. K
Why does the sink leak around the connection where the Pop-Up Assembly attaches to the Drain Body?
Fitting that holds pop-up assembly tight to drain body, or, tailpiece, needs tightened. Tighten fitting enough to stop leak, not so tight that pop-up assembly won't operate properly.
Where are the oil drain plugs on a 1989 Harley Davidson sportser?
The Oil Drain Hose is located on the leftside under the battery and is clamped to a blind (goes no where nipple) fitting. If you want to drain and change your primary then it is on the leftside under the derby cover.
