answersLogoWhite

0

What else can I help you with?

Related Questions

How the demultiplexer work?

A demultiplexer takes a single input and routes it to one of several possible output lines based on the control inputs. It essentially reverses the process of a multiplexer, allowing a single data line to be distributed to multiple destination lines. The demultiplexer selects the output line by decoding the control input signals.


How do you draw 16 to 1 demultiplexer?

To draw a 16-to-1 demultiplexer, start by creating a box labeled "16-to-1 Demux" with one output line and 16 output lines. Connect 4 select lines (S0, S1, S2, S3) to the input of the demultiplexer to control which of the 16 outputs is activated. Draw the 16 output lines branching from the box, labeling each output from Y0 to Y15. Finally, indicate that the single input signal is fed into the demultiplexer, which directs it to one of the 16 outputs based on the selected input combination.


Introduction multiplexer demultiplexer?

A multiplexer, commonly referred as an input selector, is a circuit with many inputs but only one output: it has some data inputs, control inputs and one output, depending on the control inputs, one input from the data inputs is sent to the output .A demultiplexer is a circuit with one data input, few control inputs and many outputs, it is also known as output selector.


What is Demultiplexer in Digital Logic Design?

45A demultiplexer is the opposite of a multiplexer. In electronic devices, a demultiplexer is a logical circuit which takes a single input and sends out this input to one of several outputs available. During this process the output that has been selected is assigned the value 1, while the other outputs are assigned the value 0. The definition is slightly different when we are talking about demultiplexers in the context of networking. In the networking context, a demultiplexer is a device that receives multiple signals that have been transmitted on one line and then decodes these single line signals into separate multiple signals. A demultiplexer is usually always used in tandem with a multiplexer. Demultiplexers can be analog demultiplexers or digital demultiplexers. Digital demultiplexers generally function as decoders.


What is the application of demultiplexer?

A demultiplexer is an electronic device that separates a multiplex signal into its component parts. It is used when a circuit wishes to send a signal to one of many devices.


What are the application of demultiplexer?

Demultiplexing, or separating several previously multiplexed signals.


Function of demultiplexer?

A demultiplexer is a circuit. It has one input but more than one output. A demultiplexer gives binary information from one end to another. It is used to connect a single source to many destinations.


How do you create address slot in HTML?

An address slot can be made with an input element. It creates a text area where you can put the address.


It is required to use an address operator when you accept an input for a string?

No.


Is address of input and output can ever be same in digital electronics?

Yes, but it depends on the specific computer architecture: some permit input ports and output ports to share the same address, some don't.


What is the application of demultiplexur?

They find use in Clock demultiplexer,Security monitoring system,Synchronous data transmission system


How many NOT gates are needed to turn on a memory IC if the address 10000001 is at the CE input of the chip?

To turn on a memory IC with an active-low Chip Enable (CE) input, you need to ensure that the CE signal is low (0) when the address 10000001 is provided. If the address corresponds to a high signal (1), one NOT gate is needed to invert the address signal to a low signal (0) for the CE input. Therefore, only one NOT gate is required to achieve this.