0
What else can I help you with?
How much does it cost to replace a toilet drain?
Depends how much of it you replace . Also how much flooring you remove if you can't get underneath.
Can you replace the toilet tank only, or do you need to replace the entire toilet?
Yes, you can replace the toilet tank only without needing to replace the entire toilet.
How much does a plumber cost to replace wax seal on toilet?
depending on your area, $80.00 on up.
Can you replace just the tank of a toilet?
Yes, you can replace just the tank of a toilet without having to replace the entire toilet fixture.
How much would it cost to buy the pieces to do a toilet flange repair kit?
The cost to replace just the toilet flange is around $5. The tricky part is knowing how to install it. If you use an outside source the cost will go up accordingly.
Can you replace just the toilet tank?
Yes, it is possible to replace just the toilet tank without replacing the entire toilet.
How much is the toilet cistern cost can it be DIY?
Toilet cistern can cost a lot since it is the most used water in the house. But there is some ways to reducing the amount of water your toilet is flushing. First fill a half gallon container with water, place the container in the tank of the toilet, lower it in to the water, replace the lid and then youÕre ready to flush.
How do I replace a wax ring under the toilet?
You can find detailed instructions for replacing the wax ring under your toilet at http://www.hammerzone.com/archives/bath/fixt_repair/toilet/wax_ring/replace.htm. It should cost around $20.00 to complete this job.
How do you replace a flapper in a toilet?
Shut the water supply off to the toilet. Flush the toilet. Pull the old flapper out and replace it with the same type. Turn the water back on and test the toilet.
Can you replace the tank on a toilet?
Yes, you can replace the tank on a toilet by following the proper steps and using the right tools.
Why would you replace a toilet flush valve?
You would replace a flush valve or 'flapper' when it gets distorted or leaks slowly as they all eventually do. Take it out and go to Home Depot and you will see many better ones than there were when your toilet was made. Average cost $6-10.
How can I replace toilet bolts?
To replace toilet bolts, first turn off the water supply and flush the toilet to empty the tank. Remove the nuts securing the bolts at the base of the toilet. Lift the toilet off the bolts and replace them with new ones. Place the toilet back in position and tighten the nuts. Reconnect the water supply and test for leaks.
