answersLogoWhite

0

the purpose of the pressure switch is to insure that a draft is established with the flu, this switch is normally open and as the inducer ramps up the pressure switch closes at predetermined set point, upon closing this sends signal to board to energize HSI and ultimately gas valve.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Does a 2001 doge neon have a low oil switch?

It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.


What is the purpose of pressure?

the purpose of the pressure switch is to insure that a draft is established with the flu, this switch is normally open and as the inducer ramps up the pressure switch closes at predetermined set point, upon closing this sends signal to board to energize HSI and ultimately gas valve.


What is the porpose of a Leak detection pump pressure switch?

The purpose of a leak detection pump pressure switch is to immediately alter the system to pressure drop. These are most commonly associated with seal or valve failure.


What is the purpose of the test furnace pressure switch and how does it contribute to the overall functionality of the furnace system?

The purpose of the test furnace pressure switch is to ensure that there is proper airflow in the furnace system. It contributes to the overall functionality by detecting if there is enough air pressure for the furnace to operate safely and efficiently. If the pressure is too low, the switch will prevent the furnace from turning on, preventing potential safety hazards.


What is the purpose of a pressure switch on a well pump and how does it function to regulate water pressure in the system?

A pressure switch on a well pump is used to regulate the water pressure in the system. It functions by monitoring the pressure in the water system and turning the pump on or off to maintain a consistent pressure level. When the pressure drops below a certain point, the switch activates the pump to increase the pressure. Once the pressure reaches a set level, the switch turns off the pump to prevent over-pressurization. This helps to ensure a steady flow of water and prevent damage to the pump and plumbing system.


What is the purpose of an ac low pressure switch?

It turn off the compressor to keep the evaporator from freezing up which can cause system damage.


Does a oil pressure switch monitor the oil level?

A pressure switch reads pressure not level.


What is the purpose of a disposal air switch and how does it work?

A disposal air switch is used to turn a garbage disposal on and off without the need for an electrical switch near water sources. It works by using air pressure to activate a switch that controls the disposal unit.


What does a ac pressure switch do?

A pressure switch a valve that shuts off the unit when the pressure is to low or to high


Will you lose pressure if a pressure switch stays on on a well?

if your pressure switch acts up at all, replace it.


How do you check if the low pressure switch on a corvette 1977 is working?

Of which low pressure switch are you speaking? Engine oil pressure switch? If you're checking that, remove the oil pressure sending unit and temporarily put in an oil pressure gauge. If you're checking the AC low pressure switch, pull the switch from the AC low pressure line, Jumper the switch socket and see if the AC compressor comes on. If it does, you either have low refrigerant pressure or a bad switch. If you KNOW the pressure is up and everything else works, you have a bad switch.


How do you replace pressure switch on jacuzzi spa?

To replace the pressure switch on a Jacuzzi spa you need to disconnect the wires from the thermostat to the pressure switch. Remove the pressure switch, replace with new one, and reattach the thermostat wires.