The top of a pipe is commonly referred to as the "pipe cap" or "pipe end." In Plumbing and construction contexts, it may also be referred to as the "opening" or "terminal." If discussing the pipe in terms of its cross-section, the top can simply be called the "top edge" or "top surface."
Abe Lincoln's hat was called a stove pipe hat because the rise is so tall and straight with no flare that it resembles the length of a pipe. Your welcome
Is the top portion or bottom portion of the curve of the pipe.
Granted that the force was enough to crack the pipe, it would crack in the middle.
Throat pipe or wind pipe
Near the very topThe crown of a pipe is at the very top of the inside.
On a Ship, the anchor chain is fed through a Pipe called the Hause Pipe.
The Overt is the top of a pipe at a point on its outer wall. ie the soffit + pipe thickness - Often used when surveying an exposed pipe when unable to use the invert or soffits.
The pipe must be fixed (not rolled) in the horizontal position. With the pipe horizontal, the weld is vertical. The pipe being fixed requires the welder to weld flat (top), vertical (sides), and overhead (bottom). The pipe must be fixed (not rolled) in the horizontal position. With the pipe horizontal, the weld is vertical. The pipe being fixed requires the welder to weld flat (top), vertical (sides), and overhead (bottom).
A pipe extended above the roof level is a soil pipe.
The tunnel that magma goes through to reach the top of a volcano is called a conduit. This conduit is often a vertical pipe-like structure that connects the magma chamber beneath the volcano to the surface.
On a 2.7L the thermostat is on the lower hose. If you are looking for the part on top it is called the upper water outlet. On a 3.5L it is called a thermostat housing.
The inner pipe of jacketed pipeline is normally referred as CORE pipe.