0
What else can I help you with?
What is an electronic hand shake?
It usually pertains to the noise often associated when connecting to a fax machine or connecting to Dial-Up internet.
Switched on the racing chip and pushed the gas to the floor and your motor went from running fine to making a horrible noise and then went dead and when you tried to recrank it wont crank?
Depends on the type of "horrible noise" it made. A screeching sound would probably be a bearing seizing. Not good. A clunk or thud would be a connecting rod or something in the head breaking. Worse. Putting in a "racing chip" with no other modifications is asking the motor to work harder than it is really intended to.
What does it mean when there is a knocking noise from the engine when you let off the gas?
A bad connecting rod bearing can do this
Will a CV joint make a horrible grinding crunching noise in the front wheel?
It can when it has failed.It can when it has failed.
How can a connecting rod noise be isolated?
For testing purposes only you can disconnect and reconnect one spark plug at a time. When you get to the cylinder with the bad rod bearing the noise will stop.
What could be the problem if your Chevy S-10 is making a knocking noise?
Bad bearing? Bad connecting rod?
What is wrong if it makes a loud squealing noise when driving?
either your hand brake has got something wrong with it and is stickingm, so that makes your tires rub against the road which makes a horrible noise!
What makes your 1993 ford escort die when turning steering wheel to the right?
If its making a horrible grinding noise, it could be the bearing!
What does a failing connecting rod sound like?
it sounds like a loud metallic tapping noise that you won't mistake for anything else
My Nerf Vulcan EBF-25 is making a horrible grinding noise and not shooting What should i do?
check the belt and make sure a bollet is not jammed
What would make a ticking noise when you reach 2500 rpms?
well it sounds like your lifters are ticking The connecting rods screaming LET ME OUT!!!
Why would a 1994 Olds Cutlass Sierra make a horrible popping noise when you start it until you put it into drive?
Possible loose convertor bolts.
