answersLogoWhite

0

There should be a non return valve on the cold water side of the hot water tank. When there is no non return valve the water in the tank heats up and expansion of the water will cause it to travel backward up the cold water pipe thereby equalising the waterpressure normally this expansion would find its way out of the safety pressure valve. So it sounds like the non return valve needs fitting or replacing.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you flush the heater core on 2003 s10 truck?

I would disconnect both heater hoses from the engine, then fabricate a way to connect a garden hose to one of the hoses leading to the heater, then gently turn on water supply for a minute, then attach garden hose to opposite heater hose and flush again, then reattach both hoses to engine and top off coolant reservoir.


Is the hot water heater gas and electric?

Gas heater & electric heater both are available.


How do you blow out a heater core?

I disconnect both heater hose off of the engine, then fabricate a fitting that will attach a garden hose to one of the heater hoses. While directing the other hose towards a bucket, I gently turn on the water supply to wide open and let the water run until it shows clear, then reverse the flow into the heater by switching hoses and repeat.


Should both thermostats on a water heater be set to the same temperature?

Yes, both thermostats on a water heater should be set to the same temperature to ensure consistent and efficient heating of the water.


What is installed on the hot water outlet of the water heater to change it from galvanized-steel pipe to CPVC?

I would use hot water conn. on it. Both on cold and hot


Why is hot water coming out on cold side on an water heater?

This could be caused by a faulty mixing valve in the water heater, which is allowing hot water to mix with the cold water supply. It could also be due to a crossover in the plumbing system, where hot and cold water lines are connected. Both of these issues can be diagnosed and repaired by a plumber.


Why won't my heater blow on my 1993 Buick Roadmaster?

flush the heater core in both directions with water


911 Water Heater The Woodlands TX?

Is you water heater making unusual & strange noise? Do you have a water leak? Both are signs that your water heater is about to fail & malfunction. Give 911 Water Heater The Woodlands TX a call for immediate help as you don't want to experience daily life without hot water!


Can you conect your dryer to a heater circuit?

Not advisable. Both units consume huge amounts of Amps (amperes = current) and the normal 20 or 30 amp breaker may not sustain prolonged operation of both. Where I live, we have two electric meters ... one just for the water heater, the other for the house and all it's electrical needs (except for the water heater).


What type of waterheater would be placed in basement?

You can place any type of gas or electric water heater in a basement. I have seen many of both.


What causes you to have a good supply of hot water at times and at other times barely have half a bath of hot water?

When there is not enough hot water, it probably is caused by someone using the hot water recently and the water heater is not large enough to provide hot water for both uses. The water heater will provide hot water as long as there is hot water in it. When there isn't any hot water left, it will provide cold water. It takes a while to heat the water after some is used.


What are the differences between a combination boiler and a hot water heater, and which one would be more suitable for my home?

A combination boiler provides both heating and hot water, while a hot water heater only heats water. A combination boiler is more suitable for smaller homes with limited space, as it is more compact and efficient. A hot water heater is better for larger homes with higher hot water demand.