answersLogoWhite

0

Assuming you are talking about the handle near where the trigger is situated, the hole on the underside is for storing on spare dart which can be removed and used whenever you need it. I don't personally use it much; It's just one shot, and it can fall out, however it is useful for adding it into an unfilled 'Nerf n-strike clip system' dart clip.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the hole in the handle of a Nerf raider cs-35?

if you are talking about the hole in the bottom of some of the handles those are to hold an extra dart


What is the standard size of a door handle hole?

The standard size of a door handle hole is typically 2-1/8 inches in diameter.


How can I remove a Delta shower handle that does not have a set screw?

To remove a Delta shower handle without a set screw, look for a small hole or slot on the handle. Insert a flathead screwdriver or an Allen wrench into the hole and twist counterclockwise to loosen and remove the handle. If there is no hole or slot, try gently prying the handle off with a flathead screwdriver or a handle puller tool. Be careful not to damage the handle or the surrounding area.


How do you use the spare tire mount in a silverado?

Get your jack handle out from under your back seat ( that's where mine is ) and there is a hole in the rear bumper probably on the right side by the licence plate. Put it in that hole and you will find a place for the end of the jack handle. It is @ a slight angle. Turn the jack handle counter clockwise to lower your spare tire to the ground and clockwise to raise it back in place. Jef


How is the Raider Nation different from other football fans?

The Raider Nation is different from other football fans because they are known for attending games in elaborate costumes and they are associated with a section of the Oakland Coliseum known as the "black hole".


How do you remove spare tire of 2002 eurovan?

where is it mounted/located ?is there a large wing nut holding it in place?if so then un screw itif it is mounted under back of van then you may need the long jack handle extension tool in the van and find the round hole in the bumper and insert the handle extension in the hole and unscrew the mechanism with the tool and the wheel will starts rotating and falling from under the van


How do you lower sparetire from under the car?

depends on the type of car but most newer cars have a hole in rear bumper to insert the jack handle and crank down the spare


How do you handle your boyfriend when he changes on?

you slap him in his face and call him an a**hole


Can you put a scope on a tippmann bravo one gun?

Not unless you get the handle adapter and drill a hole in the carry handle.


What does birdie mean in golf?

A birdie is one stroke under par on a given hole.


a hole in the side of a hill or under the ground?

A hole in the side of a hill or under the ground is known as Cave.


How do you remove the spare under bed of 1997 GMC?

Insert the jack crank handle into the hole in the back near the license plate and crank the spare down until you can release it from the cable.