answersLogoWhite

0

the rest of the cells are dead or you are using a charger that only has a output pressure of 6 volts.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How many amps needed to change 6volts to 12volts?

You cannot increase voltage by adding amps.


What voltage is a lawn tractor battery-6v 0r 12v?

Although it really depends on the model, most are 12V.Do You Have The Old battery how many cells does it have,most 6volts have 3cells and 12volts have 6.It all depend on the tractor some use a motorcycle battery.


Wiring 12 volts DC to get 24 volts DC?

negative - on battaery 1 goes to ground positive + on battery 1 goes to negative - on battery 2 positive + on battery 2 goes to your power requirment can be done in any case senario e.g 2-6volts to get one 12 and 1-12 24 or 4-6volts 12-volts 4 12volts any case senario negative - on battaery 1 goes to ground positive + on battery 1 goes to negative - on battery 2 positive + on battery 2 goes to your power requirment can be done in any case senario e.g 2-6volts to get one 12 and 1-12 24 or 4-6volts 12-volts 4 12volts any case senario


Is it 12 or 6 volts a 1974 125 Honda motorcycle?

for the relay switch 6volts, for the battery... dunno- mine's a 250 and uses an ATV battery.. I think they're 12 volts.


Do you charge a battery for a tractor on 6V 2amps or 12V 6 amps?

6volts 2amps for 6 volt battery, and 12 volts 6amps for a 12 volt battery. Don't charge a 6 volt battery on the 12 volt setting or it will explode!!!!!!!!! you're ok going the other way though.


Sensitivity of LVDT at 10V DC signal?

at 1 khz is .6volts


How do you convert a tractor form 6volts to 12volts?

Depending on the specific tractor, it may be different. But generally speaking, you will need to replace the starter motor, alternator, fuse block, and bulbs to a 12 volt model for that vehicle. If it is a gasoline engine, then your ignition coil will also have to be changed to a 12 volt. Further depending on the wiring used from the factory, you may, or may not have to replace it with proper gauge wire for the increased voltage.


What happens when a bulb of 6volts used in an circuit?

depending at the kind and high at the voltage, or/and the high of the power


What is the volts when 1.5v. batteries are wired in series as the total source.?

All batteries connected in series have additive voltages. All same voltage batteries connected in parallel have the same voltage as one of the parallel battery but their amp hour capacity is increased. Example series wound batteries of four 1.5v batteries, would lite a big 6v flashlight. (all 1.5v batteries = Et= 1.5v x4=6volts). That is the big square battery to lite square flashlights.


What is the volts when 1.5v. batteries are wired in series as the total source?

All batteries connected in series have additive voltages. All same voltage batteries connected in parallel have the same voltage as one of the parallel battery but their amp hour capacity is increased. Example series wound batteries of four 1.5v batteries, would lite a big 6v flashlight. (all 1.5v batteries = Et= 1.5v x4=6volts). That is the big square battery to lite square flashlights.


What is a protective resistor?

The protecting resistor is put in series with the LED so that you have a voltage divider - the supply voltage is split across the LED ( max 0.6v) and the remainder across the protecting resistor. So if your supply is 6volts, 5.4v will be across the resistor,


What is code 43 for a 92 rs camaro?

Code 43 means Electronic spark control Check the voltage at the ecm a-b connector terminal B7 it should be over 6volts unless the system is sensing detonation.Check for a loose connection.Replace the ESC sensor and/or module