what are the colors of the wires for the rear window defroster coming from the rear window to the defroster bottom ? can any body help me
That would be EXTREMELY unlikely that any rear window regulator would fit in the front window, same side or not.
To open the rear window on a 1999 Honda Passport, locate the rear window release button on the driver's side door or the center console. Press and hold the button to unlock and open the rear window. If the window does not operate, check the fuse or the window motor for any issues. Always ensure the vehicle is in a safe position before attempting to open the window.
The only window that is heated in any car is the rear window. As far as I know ther's no such thing as a power heated window
Ssi
To open the rear window in a 1984 Corvette, locate the window release lever or switch, typically found on the center console or dashboard. Press or pull the lever to release the window, which will then lift upwards. Ensure the vehicle is in the proper mode for window operation, and check for any obstructions if the window does not open smoothly.
The most common reason for any window washer malfunctioning is the washer fluid is low. Rear window washers can be more complex than front ones, so if the washer fluid is not the problem, it needs to be looked at by a mechanic.
To install the rear window in a 1991 Toyota MR2, first ensure the window and surrounding area are clean. Apply a bead of urethane adhesive to the window frame and carefully position the rear window, aligning it with the frame. Press firmly to ensure a good seal and allow the adhesive to cure as per the manufacturer's instructions. Finally, check for any leaks after the adhesive has set.
To remove the rear hinged window from a 100 Series Land Cruiser, first ensure the window is fully closed. Then, carefully remove any trim or covers around the window to access the mounting bolts. Use a socket wrench to unscrew the bolts securing the window in place. Finally, gently lift the window out of its frame, being cautious not to damage any surrounding components.
To install the rear window of a 1999 Chevrolet Suburban, first ensure that the vehicle is parked on a level surface and the rear frame is clean and free of debris. Apply a bead of adhesive around the window opening, then carefully position the rear window into place, ensuring it aligns with the frame. Press firmly to secure the window and allow the adhesive to cure according to the manufacturer's instructions. Finally, reinstall any trim or molding that was removed during the process.
To remove the rear power window on a 1991 Ford Bronco, first, disconnect the vehicle's battery to ensure safety. Remove the rear door panel by unscrewing any screws and carefully prying it off to access the window mechanism. Disconnect the wiring harness from the power window motor and remove the motor by unscrewing it from its mounting. Finally, detach the window from the regulator and lift it out of the door frame.
The rear window glass on a Honda Civic is held in place by a silicone sealer. Remove the old glass be prying it away from the car. Clean off any residue of the sealant. Properly line up the window and use the silicone sealer to glue to window to the car.