It's an ECM setting. You would need to change the settings in the ECM.
Idle Talk - 2013 was released on: USA: 26 February 2013 (internet)
To set the base idle on a Nissan Pulsar N16, first ensure the engine is at operating temperature and is in park or neutral. Disconnect the Idle Air Control (IAC) connector to disable the idle control system, then adjust the throttle stop screw until the idle speed reaches the specified RPM, typically around 750-800 RPM. Reconnect the IAC connector and turn off the engine. Finally, restart the engine to confirm that the idle speed is stable.
Could be a vacuum leak.
Tevon Plunkett has: Played Raver 8 in "Uncanny X-Men" in 2012. Played Tank in "Idle Times" in 2012. Played Jumbo in "Passport" in 2013. Played himself in "Idle Talk" in 2013. Played Razor in "Zone Three" in 2013. Played Stixx in "Selfish Desires" in 2013. Played Charlie in "Loud" in 2014.
To turn off the idle standby option on a Sony Bravia LED EX52, go to the TV's main menu and select "Settings." Navigate to "System Settings" and look for "Auto Standby" or "Idle Standby." Set this option to "Off" to disable the feature. Be sure to save your settings before exiting the menu.
Sy Sayonara has: Played Jennifer in "Chronicles of Passion" in 2011. Played herself in "The Nadej Show" in 2012. Played Savnannah in "Idle Times" in 2012. Played herself in "Idle Talk" in 2013. Played Kandi in "Selfish Desires" in 2013.
The distributor is getting ready to go out!!!Get a new one.
try changing fuel filter first. it could also be the catalytic converter. that can get plugged up and cause your vehicle to lose power.
Idle is an adjective (idle threats) and a verb (to idle).
Idle Thoughts of an Idle Fellow was created in 1886.
most idle
It's programmed into the ECM. There's a number of ways people attempt to do this, but how successful they are depends on the ECM programming. You can try putting the vehicle into high idle... sometimes that works... you put the cruise control on while the vehicle is parked and the brakes are engaged, then use the "Resume/Accel" button to increase the idle. However, a company might disable this feature, or set up the ECM so that the idle shutdown timer remains in effect while in high idle. You can try keeping your trailer brakes locked and your tractor brakes released.. it may or may not work, again dependent on what's programmed into the ECM.