0
To read codes on a Jeep Comanche, you'll need to locate the diagnostic connector, typically found under the dashboard near the steering column. Use a jumper wire to connect terminals A and B of the connector, then turn the ignition key to the "on" position without starting the engine. The check engine light will begin to flash, indicating the trouble codes; count the flashes to determine the code. You can refer to a code chart specific to the Jeep Comanche to interpret the codes.
What else can I help you with?
86 jeep Comanche pickup 2wd?
Yes, many of them. These were very commonly sold as new in Florida.
What type of oil in an 86 jeep Comanche 2.8l engine?
The recommended type of oil in a 1986 Jeep Comanche 2.8 liter engine is 10 W 30. This oil can be purchased at any auto parts store.
Will a Jeep Comanche fit a 350?
a Chevy 350 small block will fit into a 86 jeep comanche with some modifications. -A 350 small block will fit in a 86 comanche without modification just be prepared for a lot of work beacuse when you do that the ENTIRE driveline needs replaced all the way back to the knuckles on the u joints at the differentials. you will also need to adjust the motor mounts. but nothing significant.
What size gas tank does your 89 jeep Comanche have?
I have an 1986 Jeep Comanche with the long bed. I just replaced the gas tank and it is 23.5 gallons. Bought it from J.C. Whitney and it was a OE replacement. I understand the short beds (not available in 86) have an 18 gallon tank.
Where is the oil sensor lacated in Jeep Comanche 86?
on a 2.5L AMC four it's located above the passenger side engine mount.
What size rear end comes stock in an 86 Jeep Comanche?
Usually a Dana 35, unless it has the metric ton package. Then it would have the Dana 44.
Where can you find a brush guard rain guards rear leaf springs and other parts for a 86 jeep Comanche?
rustysoffroad.com has new leaf packs 269.00 a pair
What is gross weight of 86 Jeep Comanche?
The gross weight of a 1986 Jeep Comanche typically ranges from approximately 4,100 to 4,600 pounds, depending on the specific configuration and options. This includes the weight of the vehicle itself as well as the maximum load it can carry. It's important to check the vehicle's specifications or the owner's manual for the exact gross vehicle weight rating (GVWR) for a particular model.
When did the Jeep Wrangler first come out?
between 86 and 87. jeep stopped making the cj7's in 86
Why does your 86 6cyl knocks when starting?
Why does 86 jeep cj7 6cy knocks when starting
Will 86 jeep trans fit 87 jeep?
It sure will, as long as the engines are the same
Why does my 86 Jeep Comanche truck idle but not run?
If your 1986 Jeep Comanche is idling but not running, it could be due to several issues. Common causes include fuel delivery problems, such as a clogged fuel filter or a failing fuel pump, which prevent adequate fuel from reaching the engine. Additionally, ignition system issues, like a faulty spark plug or distributor, could also be to blame. Checking these components can help identify the underlying problem.
