To reset the computer on a 2006 Chevy Colorado, disconnect the negative battery cable and leave it off for about 15 minutes to clear the stored codes. After that, reconnect the cable and turn the ignition to the "On" position without starting the engine for a few seconds. This will allow the computer to reset. Finally, start the engine and let it idle for a few minutes to reinitialize the systems.
replace the tranfer case tccm...
The computer had to be reset. Had the same problem and thought it was a sensor but only took the computer being "reset" by the dealership. Cost $200 in Dallas area. The problem is not with the computer. this is a common problem on all 03-06 GM Vehicles if you wanna get it fixed Just go to www.speedomtergaugerepair.com They fixed my instruments cluster on my 2004 Chevrolet Silverado. They charged me $150 to replace all the gauges in the cluster. here is the address in case you wanna check it out: www.speedometergaugerepair.com
Alejandro Colorado was born on 1984-06-09.
Reset Speed was created on 2002-06-24.
How do i get headlight out on 06 hhr
I have an 06 Colorado and there was a recall on them for that. Might be something to check into.
On a 2006 Chevy Colorado with a 5-cylinder engine, the cylinders are numbered from front to back. The numbering starts with cylinder 1 at the front of the engine (the side with the accessory drive) and continues to cylinder 5 at the rear. The engine is laid out in a straight configuration, so the numbering follows a simple sequential order.
Colorado Territory - film - was created on 1949-06-11.
how can I reset the security system on my 06 saturn vue
Fram ph3506
Jeep does not use inertia/reset switches.Jeep does not use inertia/reset switches.
Disconnect one cable of your battery and turn the car key to ignition position two times, connects your battery and turn the car key to ignition.