answersLogoWhite

0

there is 100 ac Voltage in phone line in Pakistan

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the voltage of telephone line in Pakistan ptcl?

it has 52volt dc off hook


A telephone-repair technician uses a meter to measure voltage on a phone line. This meter is an example of .?

it is hardware not software


What country phone number is 00923467766716?

Pakistan


What is edge speed in electronics?

A voltage is applied to a signal line. The voltage of the line changes gradually from 0 to +V. The "edge speed" is the rate of change of voltage of the line. A voltage is applied to a signal line. The voltage of the line changes gradually from 0 to +V. The "edge speed" is the rate of change of voltage of the line.


From which country does the Durand Line Separate Pakistan?

Durand Line separates Pakistan from Afghanistan


What is the poverty line in Pakistan for 2010?

poverty line in Pakistan for 2009 was 848.79 rupees.


What voltage and Hz does Pakistan use?

220VAC at 50Hz


How do you convert 3 phase RMS line-line voltage to RMS line-neutral voltage on an unbalance system Basically how do you calculate using trig for all 3 phase?

The term, 'unbalanced system' refers to an unbalanced load. Under normal circumstances, an unbalanced load leads to unbalanced line currents. The line voltages are determined by the supply and remain symmetrical, even when the load is unbalanced. As your question refers to a 'line to neutral' voltage (i.e. a phase voltage), you must be referring to a star (wye) connected load, in which case the phase voltage (line to neutral voltage) is 0.577 (the reciprocal of the square-root of 3) times the line voltage (line to line voltage).


Is 220V line voltage or phase voltage?

Phase, if you are referring to line, as power line from pole.


Where is the fault line in Pakistan?

The Chaman Fault is the major fault line in Pakistan. It starts just off the coast of Pakistan and travels northeast through Pakistan in into Afghanistan.


How do you convert 440 voltage line to voltage phase?

To convert a 440V line voltage to phase voltage in a three-phase system, you divide the line voltage by the square root of 3 (approximately 1.732). This means the phase voltage is calculated as ( V_{phase} = \frac{V_{line}}{\sqrt{3}} ). For 440V line voltage, the phase voltage would be approximately 254V.


What is the line voltage between two lines?

the voltage between 1 line & phase =120v The voltage between 2 line =240