answersLogoWhite

0

The brake caliper bolts on a 1994 Ford Crown Victoria typically use a 3/8-inch Allen (hex) socket. Depending on the specific model and any modifications, there may be variations, but this size is standard for the caliper mounting bolts. Always confirm with a specific repair manual or check the bolts directly for accuracy.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

Why would your 1988 ford ltd crown Victoria be leaking brake fluid?

Could be, Rotted brake lines, Leaky caliper(s), Leaky master cylinder,


Where is brake light switch 1997 crown Victoria?

It's on the arm of the brake pedal.


Do factory rims from a 1990 ltd Crown Victoria fit a 1998 Crown Victoria?

This all depends if you have the larger caliper on the '98. They should fit the rear no problem, but due to the larger caliper you would have to use a 1.25 inch adapter and grind the top of the caliper a little. Of course if you do not have the larger caliper they should fit. Just try it.


How do you change front wheel hubs on 1994 Crown Victoria?

Remove brake caliper, then caliper mounting. Now tap back of rotor to remove it. Now undo large nut holding hub and pull hub off. Replace in reverse order.


How do you replace a caliper in a 96 Crown Victoria?

Remove the tire, and just unbolt the caliper, there are 2 bolts from the back. Now the caliper will just slide up and away from the rotor. If you have to replace the caliper, then check the pads and the rotor. Might have to replace them also. Be careful removing the brake line. Work it slowly so as not to break it. You have to bleed the new one. Take off the brake line first and hang it up to keep it clean.


Crown Victoria brake lights don't work?

Check the bulbs, the fuse then the brake light switch.


What does the abs light stand for on the 1996 crown Victoria?

Antilock brake system


How do you replace the parking brake cable on a 08 Crown Victoria?

very carefully


How do you remove the rear discs 2000 crown Victoria?

You have to remove the brake caliper first. Then you might have to slack the parking brake. The parking brake on read disc in inside the back of the rotor. If you cannot slack the parking brake, the you will have to hit the rotor ( with a small 5 lb hammer ) to loosen it. Might take a little time if it is stuck on.


What is wrong if the brake light is constantly on in a 1992 crown Victoria?

Normally this is an indication of a defective brake light switch.


How do you remove the rear brake rotors on a 1993 Ford Crown Victoria?

They come off much like the front. With the wheel off, remove the caliper and the rotor just pulls off. The parking brake is in the center of the hub, there fore you do not need to take anything else off.


How to remove front rotor 1996 crown Victoria?

Remove the wheel, remove the caliper, and the rotor will just come off.