The Jeep has a TDC sensor on the bell housing that tells the computer when the distributor is at top dead center (TDC). If it is inop the jeep will not run
ITS the PICK-up COIL !!!!!!! to be safe just change the distibutor
First of all you haave a super old car second i recomend you get to a auto repair before you get into any serious action
To change the ignition coil on a 1987 Jeep YJ, first disconnect the negative battery cable to prevent electrical shorts. Remove the coil wire and any connectors attached to the coil, then unbolt the coil from its mount. Install the new coil by reversing the removal process, ensuring all connections are secure, and finally, reconnect the battery. Start the engine to verify that the new coil is functioning properly.
On my 87 Comanche, Interior of the Cab drivers side fuse box long silver circuit breaker at the bottom of the fuse box. By long I mean rectangular as opposed to round. It is a circuit breaker not a fuse that controls the Wipers.
i have an 88 Comanche and mine is on the driver side underneath the headlights, almost in the wheelwell
No.
pore
the BA-10/5 transmission (made by Peugeot) found in early 87-mid 89 Comanche and Cherokee with L6, 4.0 L engine specifies 4.9 PINTS (2.45 qt) of 80wt. GL-4 specification
1,3,29, or 87... take your pick
coil wireing order on 87 d21 z24 motor truck
no.