answersLogoWhite

0

What else can I help you with?

Related Questions

How do you stop gas from coming out of the overflow tube on a crf250r?

If gas is coming out of the overflow tube on your CRF250R, it could be due to a stuck float in the carburetor. To fix this issue, try tapping lightly on the carburetor bowl to free up the float. If the problem persists, you may need to clean or replace the carburetor float valve.


How do you get more horsepower from a Honda XR80?

You can try to get a bigger carburetor for the bike. The XR80 carburetor will fit with some modifications. Another possibility is to bore the engine out to 90 cc but then you will need a different piston and rings.


What would cause gas to leak from the carburetor Harley Sportster?

Float may be stuck in carburetor, or you may need to turn the petcock to the off position when not riding (if applicable). ~RC@HD~ ANSWER: Another posibility is that the gas cap is not venting correctly and when the bike sits in the sun, presure builds up in the tank forcing gas out of the overflow vent in the carb.


How do you spell overflow?

You spelled it correctly, but in case you need it again: Overflow In a sentence: I overflowed my bathtub. Hope this helps! :)


Do lawnmower carburetor gaskets need adhesive?

No.


What would cause gas to mix with oil on a lawn tractor?

if the float/needle assembly do not seat properly. the gas will slowly leak past the needle and into the cylinder-then past the rings into the oil. you probably need a carburetor rebuild.


In which countries srilankan passport holder does not need visa?

In which countries srilankan passport holder does not need visa?


Why did you not need to know the amount of water originally in the overflow container?

You did not need to know the amount of water originally in the overflow container because it could be easily calculated with the existing information.


Why do planets need rings?

They do not NEED rings. The Earth, for example, is a perfectly well formed planet and it manages to do that without rings!


How can I replace a bathtub overflow gasket?

To replace a bathtub overflow gasket, you will need to remove the overflow cover plate, unscrew the old gasket, clean the area thoroughly, and then install the new gasket by screwing it into place. Finally, reattach the overflow cover plate.


Why are your spark plugs wet with gas?

This is typically caused by a stuck or faulty float valve in the carburetor. Usually a good carburetor cleaning will take care of it. At the worst you will need to replace the carburetor.


Where is carburetor found in car?

The carburetor is normally found just above the engine, it controls the petrol and air mix prior to combustion. Fuel injected and diesel engines do not need a carburetor.