Up 30,000 feet.
if it is crushed it can kill you esp if used w alcohol/ not for fooling with please read up on iy
To shorten a 20-meter high cypress by a third without harming the tree, you should prune it carefully to a height of about 13.3 meters. Begin by removing the top third of the tree, cutting back to a lateral branch or bud to encourage new growth. Use sharp, clean tools to make clean cuts and avoid excessive damage to the trunk. It's best to prune during late winter or early spring when the tree is dormant, ensuring proper recovery and minimizing stress.
To calculate the rise of a roof with a 3-degree pitch over a meter, you can use the tangent function in trigonometry. The rise is equal to the tangent of the angle multiplied by the run (distance), which in this case is 1 meter. Therefore, the rise is approximately ( \tan(3^\circ) \times 1 \text{ meter} ), which is about 0.0524 meters, or approximately 5.24 centimeters.
331 Meter
30
A one meter contour interval would be more likely to show a shallow1.5-meter-deep depression in the ground than a five meter contour interval, because itshows more frequent changes in elevation.
The employee read the gas meter.The item was 1 meter high.
Nope, when the meter's broke there ain't no-one can read it.
you just have to do 50*12 and that equals 600!
read owner's manual
No but you can use a volt meter to read voltage.
Mount. Erebus.You can read more by following the link, below.
A meter is equal to approximately 39.37 inches. Therefore, a parking meter that is one meter high would be approximately 39.37 inches high.
A glucose meter reads the amount of glucose in the bloodstream. This is particularly important for those who suffer from certain types of diabetes, where their glucose levels get either dangerously low or high.
your blood glucose may be too high for meter to read or bad test strip
meter exponent two...
Alternator may not be charging battery sufficiently Check with a voltmeter A fully charged battery should read approx. 12.8 volts without engine running With engine running meter should read approx. 13.8-14.2 volts