Military aircrafts don't disable their transponder beacon when flying in enemy airspace, they change the settings on it though.
Generally no, but if used around any naval base or military aircraft facility you run the risk if their radar systems causing major damage to your equipment due to the strength of their systems.
A large EM Pulse would disable navigation and most control systems on aircraft such as A 380.
To disable the immobilizer on a Vauxhall Vectra 2 DTi, you typically need the vehicle’s key with a programmed transponder. If you’ve lost the key, you may need to use specialized diagnostic equipment or reprogram a new key at a dealership. Attempting to disable the immobilizer without proper tools or knowledge can lead to further complications, so consulting a professional locksmith or Vauxhall dealer is recommended.
Japan's attack on Pearl Harbor was an attempt to disable the US Navy. Fortunately the aircraft carriers were not in port and the effort was unsuccessful.
If you no longer have the remote key you will need a transponder (chip) key. You can get one from the dealer, or there are some other places that sell them. You will have to use that key in the Drivers door to unlock the door and this will disarm the alarm.
Don't kill your husband! He's disable and is a veteran. What are you thinking?!
Yes, if you were working since leaving the military. No, if you have not worked since being diagnosed as being disabled. You may be required to disclose your disable benefit amount when applying for unemployment.
To turn off the overspeed warning on a Falcon aircraft, access the aircraft’s settings through the primary flight display or management system. Navigate to the "Warnings" or "Alerts" section, and locate the overspeed warning option. You can then disable it by toggling the setting off. Always refer to the aircraft's operating manual for specific instructions, as the procedure may vary by model.
You disable it.
Some vehicles have a switch to disable the passenger air-bag. Others have a system that can detect a suitable (transponder equipped) child-seat in the passenger seat, and deactivate the air-bag while the seat is fitted. Unless the vehicle has such a switch, or is equipped with such a system, it is not normally possible to disable the passenger air bag without also disabling all the air bags and seat-belt pre-tensioners. For this reason it is recommended that child seats be fitted in the rear, or that those with medical reasons that make an air bag "undesirable" are seated in the rear.
Disable is a verb.
To disable a span element, the command disable () has to be used. The command disable () stores the address of the element as the node of the parent address.