To turn a Trax switch back on, locate the power switch on the unit, typically found on the side or bottom. Make sure the device is plugged in and then toggle the switch to the "on" position. If the switch does not respond, check the power source and ensure any necessary batteries or connections are secure. Lastly, refer to the user manual for specific troubleshooting steps if issues persist.
Turn headlight switch to the left to turn off daytime runnig lights. Turn switch back to left to turn back on.
The turn signal flasher is combined with the hazzard switch. It is connected to the back of the hazzard switch.
Pull the turn signal lever toward you to switch to high beams and back again Pull the turn signal lever toward you to switch to high beams and back again
try to start it turn switch off and back on and leave the switch on for 10 mins. try to start again and turn the switch off and back on for another 10 mins.try to start again turn the switch off and back on for another 10 mins.this should reset the computer and it should start
Turn off the switch in the back and then turn it on again.
You pull back on the turn signal switch. If that doesn't work then you may have a bad dimmer switch.
switch it off turn it back on again
look where the turn signal switch is and pull it back towards the steering wheel, that turns on the brights
They turn on and off by taking the battery out and putting it back in or if it has a switch then you could use that.
no. try replacing the headlight switch... eBay
It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.
Ur life suck that why