do you have cap locks on, but even then you could probly still do it.
Cheak the key configurations and see if that is still the correct key and if not assign it.
Press the power button on the console, or if you have a Wii Remote connected to the console, the power button on the remote. The power button on the console is located to the top-left of the disk slot, and above the D-Pad on the remote.
tilde is the button for console looks like: ~ located under escape key. hit: shift + (button under esc.) Some keyboards have the tilde above the right shift button. However the console button is still the one under the escape key.
It is on above of right vent the button is there on the top of middle vent console
you need to hit the "`" button this is the button left of the "1" and above the "tab" then type in the commands.
Self Destruct
There is a small button between the triggers on your controller. Press and hold that button until the lights around the home button go in circles. There is also a small button on the console that is located above the USB ports and to the left of the power button if your console is oriented so that the disk driver is at the top. Press that button too and your controller should now be synced with your console.
There's a red button inside the remote's battery compartment and another one in the SD card slot on the console (right above the eject button and below the reset button). Push the 2 red buttons simultaneously and they will sync
you pull the two latches above the sun visors and then there is a button on the center console
Below steering column on console panel, above brake pedal
Generally on the dash above the radio, or if you have a overhead console it could be there!
i bet people have told you to press ~ NO you really press ` ( the button next to 1 and above tab)
On my 2002 VUE I pressed the RCL and SCN buttons simultaneously and adjusted the time with the + and - buttons above and below the mode button.