Hey well i own an in ground liner pool and for a few years now i have heard that i cannot just slap tiles on the walls. they have told me the walls arent stong enough to support the volume of water in my pool my deal is how cant they they already do support the weight the 5 mm thick vinyl sure as hell isn't helping so i say go ahead tile away be sure to check what kind of grout to use an be sure to tile with freeze resistent tile if freeze is applicable in your area. have fun!!-georg
If it was working ok before you lined it and you have no problems removing the liner you should have no problems.
All day long. Concrete pools have real tile instead of the fake liner tile look. You can update a concrete pool later on as styles change: with vinyl it's final.
there is a company that has a dealer base across the country called Fiber Tech. You will have to have a concrete floor but other than that they line your pool with fiberglass and special resins giving you a product with a 25 year warranty. They are located in Largo FL.
The experts at Advanced Pool Coatings have been installing fiberglass coatings over vinyl liner pools for over 30 years. You can read more at: http://www.advancedpoolcoatings.com.
It would depend on what kind of an in-ground pool you refer to, i.e. gunite, concrete, block, vinyl liner, wood, or fiberglass.
no on paint! You will need to replace the liner.
I say gunite for the ability to create any shape pool you desire. Otherwise, you are stuck with the pre-fab design of the vinyl variety.
Gunite is covered with plaster. It is sprayed on concrete sorta. They mix it in the hoses and it is blown on. You can go to youtube and see them gunite a pool. I am only aware of plaster, vinyl or painted pool surfaces. The vinyl is just like thin rubber.
No
Wood wall pools will often deteriorate faster than traditional galganized steel wall vinyl pools. Vinyl pools are the most economical where as concrete pools tend to be more luxurious. If you want to see a side by side comparison of all different types of swimming pools you can choose from at www.BuyPool.ca which is an article comparing the purchasing quality of: -Vinyl liner abover ground pools -Vinyl liner in ground pools -Concrete or gunite in ground pools -Fibreglass pools
A very limited few were intentionally built that way. Usually in very low lying areas where cement/vermiculite allowed too much water to come through, making it impossible to "seat" the liner. However, this scenario does apply more to concrete than gunite. Gunite pools have a very short life (less than 20 years) of troublefree enjoyment, then the cracks, leaks, stains, and algae take over. Pool owners try either paint, epoxy, or new plaster. None of these solutions last more than three to four years, then they are forced to start over seeking a solution. Then, along comes a liner salesman with, what sounds like, THE answer. They will nail a "bead receptor" around the top of the pool, then install a beautiful, long lasting vinyl liner into the pool, with a 10 year warranty (pro-rated by the way). These pro-rated warranties are a bad joke, as every vinyl liner pool owner already knows. Nevertheless, after the last debaucle with two-part epoxy, plaster (marcite), or paint, this sounds like the obvious answer. Unfortunately, it is the worst answer of all! It won't even last three years. The bead receptor must be a part of the concrete deck around the pool, it can not be, under any condition, added later. That is why a gunite pool could have a vinyl liner.
Yes, replace the liner. Nothing can put the color back into plastic or vinyl or glass or steel.