answersLogoWhite

0

Allow engine to warm fully to operating temperature without the radiator cap on. Once thermostat opens fully the cooling system will be at full flow forcing any air out through the radiator.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Is it possible to keep a small inflatable pool clean without using a pump filter system Is there a system that can sit inside the pool kind of like a pump filter inside an aquarium?

NO POWER CORDS IN THEW POOL ! I KNOW ITS HARD TO KEEP THESE CLEAN SO THE BEST WAY IS TO FIND A INGROUND PUMP AND FILTER SAY A 1 HP STA RITE DURA GLAS AND A 50 SQ FOOT CARTRIDGE TYPE FILTER. WHEN THE POOL GOES BAD YOU WILL BE ABLE TO RESELL THE PUMP AND FILTER AND GET YOUR MONEY BACK..


How do you know which is the inflow from the pump and whch is the ouflow to chlorinator on a Ranger series sand filter?

Starting at the pool first is the static skimmer then the leaf basket then the hair filter basket on the inflow side of the pump then the pipe from the pump to the filter then the pipe from the filter to the pool return The chlorinator sits on the pool return pie at the highest place in the system.


What is the layout of the plumbing system in a pool spa, as shown in the diagram?

The plumbing system in a pool spa typically consists of pipes that connect the pool and spa to a pump and filter. Water is circulated through these pipes to keep the pool clean and maintain proper water circulation. The diagram shows the layout of these pipes and how they are connected to the pump and filter.


Why are the pool jets not working properly?

The pool jets may not be working properly due to clogging, airlock, or a malfunction in the pump or filter system.


Can a pool filter cause a pump not to work?

no


What would cause bubbles to form in my pool?

Bubbles in a pool can form due to air getting trapped in the water circulation system, a leak in the pool plumbing, or a malfunctioning pool pump or filter.


What could be the cause for your pool whips to stop moving after two hours of filtration when the pressure reads normal on the sand filter?

Clean and empty in ground pool filter, clean and empty filter near pool pump. Be sure all whips are clear of dibris. also do a flush of the system. If this does not help, you will need to have a C02 charge done between the pool line and the pool pump. OR you may need to have your impeller replaced in the pool motor.


Why doesn't the pool filter run?

Pool filters do not get cloged the pump is the problem


What causes filter earth to come out the main drains in my pool?

Filter earth coming out of the main drains in your pool can be caused by a broken or damaged filter grid inside the pool filter, allowing the filter media to escape. It could also be due to high pressure in the filter system, causing the filter media to be forced back into the pool. Check the filter system for any damage or blockages, and ensure proper maintenance and cleaning of the filter.


What is the difference between filter and recirculate on a pool pump?

First of I think you may be referring to the pool filter not the pump. "Filter" runs the water thru the filter thus filtering the water. Recirculate, I believe, bypasses the filter media and sends the water back to the pool unfiltered. K


How can I use a pump to efficiently remove water from a pool?

To efficiently remove water from a pool using a pump, you should first ensure the pump is properly connected to the pool's drainage system. Next, turn on the pump and adjust the settings to the appropriate flow rate for your pool size. Regularly monitor the water level and empty the pump's filter basket to maintain optimal performance.


Do you need a pump and filter for your 10 X 30 pool that holds 1000 gallons of water?

I have a 10 x 30 pool but i don't seem to need a pump and filter!