answersLogoWhite

0

The only way to remove Hardness is to partially drain and refill your pool.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you lower cynaruic acid in your swimming pool?

The only way to lower your cya level in your swimming pool is to partially drain your pool and fill with fresh water that will lower it or if you want to lower it to almost nothing completely drain your pool and start over but keep in mind chlorine tablets will raise your CYA level More information in the related link below.


How much baking soda do you add to lower the pH level in an above ground pool?

Baking soda will almost certainly raise the pH level in a pool.


How do you lower pH level in pool?

To lower the pH level in a pool, you can add pH decreaser or muriatic acid according to the manufacturer's instructions. Test the pH level after adding the product and adjust as needed until the pH falls within the optimal range of 7.2-7.6.


Can you lower the water level for certain depth in overflow swimming pool?

7


What is the purpose of balancing tank in reflection pool?

If you have a deck level pool or spa (water level with the top of the pool, that usually overflows into a grating around the pool) when people get into the pool their body displaces water, this water is stored in the Balance tank until the people get out and the water is pumped out of the balance tank and back into the pool. A skimmer pool that has a lower water level than the top of the pool does not need a balance tank as the displacement is handled by the water level rising. Deck level pools and spas are considered more aesthetically pleasing.


How do you lower hardness in pool?

If the calcium is a result of pool chemicals, draining some or all of the pool water will lower the calcium hardness level. If the cause is the fill water, commercial hardness reducers or chelating agents will bond with the calcium to keep it trapped in solution.


How much muriatic acid is needed to lower PH?

It depends on the pH level in the pool and the gallons of the pools, also how many ppm you want to lower it.


What do you do when your pool has too much water?

You could drain it down to the correct level if you feel better about it or you can just let it come down naturally and take advantage of the free water. I have a floating pool skimmer to keep my pool clean and it makes no difference whether my pool is full or nearly empty.


How do you correct the pool water when the pH is 80 and the alkalinity is 70?

You should first determine what the TA (Total Alkalinity)of YOUR pool should be. You can do this by having the Total Hardness (not calcium hardness)tested. (Examples shown below). Then adjust the TA to where it should be for YOUR pool. Raise by adding bicarb of soda, lower by adding acid a little at a time. When the TA is where it should be, then ajust pH. Some TA levels for various TH readings: TH 100 = TA 100-110 TH 200 = TA 90-100 TH 300 = TA 80-90 TH 400 = TA 75-85 TH 500 = TA 70-80 If TH is over 500ppm AND at least 300ppm above that of the fill water, empty pool and refill.


Why does the spa water lower when the pool pump turns off and why does the spa water level go down while using the spa if the spa water is approximately 16 inches above pool water level?

The check valve between the spa and the pool is defective.


Is there any cause for concern if the chlorine level of your pool is 3 or higher?

No. You can go to 10.0. Now if you have a vinyl liner that chlor level might have to be lower. k


Is a high pH level in your pool bad for you?

High level of anything is not good for you. High pH level can be damaging for one health. I would advise you lower your pH until it reaches the right level.