answersLogoWhite

0

If they are in fact plugged with leaves you will have to call someone to force the leaves back to the pool or skimmer. This is sometimes done with a CO2 tank. Sometimes just a "plumbers helper" device that attaches to a garden hose will work. The device is put into the suction side of the Plumbing at the pump and turn on the water. Water pressure will sometimes work if it is strong enough. You are just trying to dislodge the debris just enough to move it. This procedure may take a few times to work.

k

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How can I get frogs out of my skimmer line on my inground pool?

You can buy a devise called a Jeanie Jet and it connects to your water hose. Take the lid off your pump and insert it into the front of the pump going back to the skimmer. You then turn on the water and it should blow out the line and unclog it. What comes out of that line will come out into the skimmer so watch for it.


Inground fiberglass pool skimmer leaks needs repair or replacement?

It would be easier to replace with a floating skimmer Check poolrite dragonfly


20 x 40 inground Pool skimmer seams to be plugged what steps to unstop skimmer?

try a shop vack drain the pond/pool down to the bottom of the front of the skimmer then turn the pump for 25 sec till you see the water drop in the line let it dry a bit then shop vack it


How do you keep frogs from dying in your inground swimming pool?

You really can't. You can put a "skamper ramp" on your pool to help them get out but its hit or miss they'll see it. There is a an ingenious lightweight, net device called Critter Guard that provides a ladder for frogs and other animals to use to climb out of a pool. Visit the Critter Guard Web site at or at Critterguard.net for Purchases and additional information.


How do you reduce the water level on your 10000 gallon inground pool if it is about 2 inches above the skimmer top?

you can back wash the pool and drain to proper level Throw a pool party with lots of energetic kids.


Is it ok to use a drain cleaner to unclog a pool line?

YES!


Does Justin Bieber have a inground pool or a above ground pool?

Justin Bieber has a inground pool


How do you unclog the bottom drain of a in ground pool if you can't find the junction of the skimmer and the main drain?

Depends how the pool was plummed. If you have a dedicated main drain line, or you share a main drain line and a skimmer line. Both are suction lines to the pump,meaning they will go into the front of the pump. If you have several valves on the front of the pump, and hopefully they are labeled you could try to shut all of them except the main drain and use what is called a drain king. It hooks to a waterhose and swells inside the pipe forcing water in the opposite direction. If you dont have any valves on the front of the pump ,chances are you share suction with the skimmer. check the inside bottom of the skimmer. Main drain may be plummed to skimmer bottom.


How do you install a skimmer in an in-ground pool that is 20 years old?

First of all you cut the concrete 2 paralell cuts from pool edge toward the pool equipment, jack hammer out concrete remove old skimmer and coping , plaster, etc, trench out from skimmer location to exist skimmer/drain line,set new skimmer in place plumbin to old skimmer line pour concrete around base of skimmer to set in place, wrap 1/2" rebar drilled and epoxyed into exist pool gunite, build form around skimmer and rebar, pour form with rapid set mortar, pour final layer of finish concrete, replace coping repair plaster and voila you r done


Can you drain an inground pool with the pools back wash?

Let me say first backwashing is a process for simply ridding the filter of dirt, once you backwash the pressure and cleanness of the filter will begin to collect and store more dirt from the pool, Look at the gauge at the filter remember the pressure or write it down as the pressure goes up the flow of water going back to the pool will go down to the point that very little water will go back into the pool. When the pressure is low the water flow from the filter will be high meaning that the filter is not clogged or dirty.


When adding earth to an in ground pool do you pour it in the skimmer box or into the pool it self?

Add thru the skimmer box


Why is the skimmer not working on my pool?

The skimmer may not be working on your pool due to clogging, a malfunctioning pump, or a leak in the skimmer system. It is important to check for these issues and address them promptly to ensure proper functioning of the skimmer.