You need at least 50 psi, and if there is a restrictor, remove it.
It can be but shouldn't be. If its plumbed in half inch you will have a lot of issues with pressure drops and huge drops in water pressure when two taps are opened at once.Usually 20mm 3/4 is run to the shower/s and then half inch to other fixtures
An average flow rate cannot be determined as there are many different shower heads and each house in every country has different water pressure and not everyone may use full pressure when using a shower. But, approximately said that the average flow rate of shower water 2.5 gallons per minute at a water pressure of 80 pounds per square inch.
1-1/2 inch drain for above grade and 2 inch drain for below grade. Most UPC-based codes (IAPMO) require 2 inch above and below grade.
Water pressure is the force exerted by water as it flows through a plumbing system. It is measured in pounds per square inch (PSI) and is important for ensuring proper water flow and functionality of fixtures like faucets and showers. Low pressure can result in weak flow, while high pressure can lead to plumbing issues and damage.
The optimal water pressure required for a sprinkler system to function effectively is typically between 30 to 50 pounds per square inch (psi). This range ensures that the sprinklers can distribute water evenly and efficiently across the designated area.
A 1/2 inch PEX pipe is typically not big enough for a shower because it may not provide enough water flow for a satisfactory shower experience. It is recommended to use at least a 3/4 inch PEX pipe for a shower to ensure adequate water flow.
Not many. Maybe one at best. Half inch copper line is too small for most needs. 3/4 only costs a little more. You will go completely mad waiting for a bathtub to fill with half inch lines. Every flush of a toilet will make the shower die out.
The optimal water pressure for a sprinkler system to effectively water a lawn is typically between 30 to 50 pounds per square inch (psi). This range ensures that the water is distributed evenly and efficiently across the lawn.
No, it is not recommended to use a 1 1/2 inch pipe for a shower drain as it may not provide sufficient drainage capacity for the water flow from a shower. It is typically recommended to use a 2 inch pipe for a shower drain to ensure proper drainage.
To raise water 1 foot vertically, you need approximately 0.433 pounds per square inch (psi) of water pressure. This means that for every additional foot of height, the pressure increases by about 0.433 psi. Therefore, to elevate water to various heights, you can multiply the height in feet by this value to find the required pressure in psi.
At the bottom of the Mariana Trench (Pacific Ocean), where water pressure is about eight tons per square inch.
If you wish to control the second head from the original shower control, then come off the head. That way both shower heads can be controlled from one location. Realize that the water pressure will decrease as they have a common source, which is normally a 1/2 inch line.