is guardex pH increaser compatible with bacquacil
You would be safest using Baquacil pH Increaser, which is a high purity, highly active dry alkaline product used to raise pool pH. In non-Baquacil pool water, both Soda Ash and Hydrochloric acid are used to raise pH levels. Pool shops are a good place to seek advice also.
No - Alkaline is on the high end of the pH scale, acidic is on the low end of the pH scale. Use a pH decreaser to lower the alkaline levels.
You can use soda ash (sodium carbonate), sold as pH Increaser, pH UP or Arm & Hammer Washing soda. You can also use borax, sold as 20 Mule Team Borax. Sodium bicarbonate, sold as baking soda, Alkalinity Increaser or Alk Up, will raise pool pH levels, but not very efficiently.
You want your pH to be around 7.4. This can be done by using a pH decreaser or increaser product
Small amounts of the chemical Sodium Carbonate, available at your local pool store usually packaged under a name like pH up or pH increaser.
To switch from chlorine to Baquacil, start by discontinuing the use of chlorine products and wait for chlorine levels to drop to zero. Test the water for chlorine and pH levels before adding Baquacil according to manufacturer's instructions. It may also be necessary to clean or replace the filter system to prevent any residual chlorine from affecting the Baquacil effectiveness.
A lower pH will erode a copper heat exchanger in a heater very quickly. I will also then, increase the copper level in the pool water and will make it difficult to add pH increaser or TA increaser. Both chemicals will stay out of solution. Once they do deslove the copper drops out and the will stain the liner black. The best solution is to keep an eye on your pH especially when you have a heater.
there are two primary chemicals on the merket used to do this. 1.) soda ash usually packaged under the name pH rise or pH increaser. 2.)sodium bicarbonate usually packaged under the name alkalinity rise or alkalinity increaser. both of the above chemicals will increase both the pH and Alkalinity of the swimming pool water. always make sure your alkalinity is balanced before making any pH adjustment. it is also important to understand pH and alkalinity always move together and in the same direction. so a pH adjustment will cause a change in your alkalinity level the same way a alkalinity adjustment will cause a change in your pH. when you increase pH, alkalinity will also increase when you decrease pH, alkalinity will also decrease when you raise alkalinity, pH will also rise. always dose chemicals according to the directions on the chemical container and the volume of water you are treating.
To increase the pH of RO water effectively, you can add alkaline substances such as baking soda, crushed eggshells, or a pH increaser solution. Be sure to measure the pH level regularly to avoid overcorrection.
High Alkalinity will keep your pool water on the higher end of the pH scale, or more basic rather than acidic. High Alkalinity is not terrible but there are two things that can happen. If the water is constantly basic a "scale" can develop. The other thing that can happen is you will notice your pool will get cloudy when you add pH increaser, alkalinity increaser or calcium hardness increaser when either one of those three are on the high side already.
It's generally not recommended to add shock and pH increaser at the same time in swimming pools. Doing so can lead to chemical reactions that may reduce the effectiveness of both products. It's best to wait for the chlorine levels to stabilize after shocking the pool before adjusting the pH. Always follow the manufacturer's instructions for optimal results.
It's generally not recommended to add pH increaser and chlorine at the same time. When these chemicals are mixed, they can react and reduce the effectiveness of the chlorine. It's best to adjust the pH first, wait for the levels to stabilize, and then add chlorine to ensure optimal water balance and sanitation. Always follow the manufacturer's instructions for safe and effective pool maintenance.