answersLogoWhite

0

What else can I help you with?

Related Questions

What is a skimmer weir?

A skimmer weir is the plastic flap and the opening of the skimmer. It traps leaves that are pulled into the skimmer when the pump is running and then holds the leaves in the skimmer whne the pump shuts down


Pool skimmer not working?

Empty the skimmer baskets and the basket that's attached to the pump. Then backwash and rinse the filter.


Why is the skimmer not working on my pool?

The skimmer may not be working on your pool due to clogging, a malfunctioning pump, or a leak in the skimmer system. It is important to check for these issues and address them promptly to ensure proper functioning of the skimmer.


Why is my pool skimmer not working properly?

Your pool skimmer may not be working properly due to clogs in the skimmer basket, a malfunctioning pump, or a leak in the skimmer system. Regular maintenance and troubleshooting can help identify and fix the issue.


What can you do if you opened the pool but the skimmer basket had a crack and some leaves are caught in the pump lowering the water flow?

Normally there are 2 baskets before the pump, One behind the skimmer and one on the pump. However If you only have the one basket then you will have rubbish caught in the impeller of the pump, You will have to take the pump apart and clean the impeller out.


How do you check to see if there is an obstruction in the line to the pool skimmer?

The easiest, and cheapest way is to turn the suction valves off to everything but the suspected skimmer, if your pump bowl stays full of water, it is fine, if it automatically looses suction, then you have either a break or a blockage. Put a plumbers helper in the suction side of your pump pot and blow whatever blockage you have towards the skimmer. A snake will not work here because your skimmer actually has vacuum (negative) pressure unlike a sewer line,which is not a pressurized line. tritonunderwater.com


Does the water level in the pool have to be above the skimmer to run the pump?

yes in order for the pump to work the water has to be over it


How do you attack a hose to the skimmer on a above ground pool?

To attach a hose to the skimmer on an above-ground pool, first ensure the pool pump is off. Locate the skimmer’s suction port, typically found inside the skimmer box. Connect one end of the hose to the skimmer's suction port and secure it tightly to prevent leaks. Finally, run the other end of the hose to your pool pump or vacuum, depending on your intended use.


What are the syllables in the word slurping?

There are two syllables in 'slurping'. Slurp-ing.


How can I get frogs out of my skimmer line on my inground pool?

You can buy a devise called a Jeanie Jet and it connects to your water hose. Take the lid off your pump and insert it into the front of the pump going back to the skimmer. You then turn on the water and it should blow out the line and unclog it. What comes out of that line will come out into the skimmer so watch for it.


Your pool pump is working but it is not pumping water from the pool its like there is a blockage some where what could be the problem?

could be , is the water level above the skimmer/s / are the skimmer baskets clean/? pump may have just lost it's prime. fill pump with water replace lid and restart.


How do you keep Floating Candles out of your pools skimmer?

Turning the pool pump off will help