0
What else can I help you with?
Should water always be coming out of the jets when pump is running?
No, not if the filter is set to backwash or waste.
What is a stream of water coming from a high place?
Waterfall
Why are low head dams dangerous to small boats and water craft?
Backwash can pin you and the boat indefinitely.
What is the temperature in degrees of a river or stream?
it depends on temperature of the air and where the water is coming from.
What is a stream of water coming down from a high place?
I think its a river!
What does backwash mean?
Backwash is a term used by engineers when cleaning water filters or coolers they reverse the flow and wash out the filters or coolers
What is coastal backwash?
This is the movement of water in a wave form back to the sea
When you backwash your pool why does the water come out forcefully when other pools in the neighborhood seem to trickle?
Each time I backwash my pump head, the water comes out with extreme force. It has only trickled when something was going wrong. The pump may have been drawing air or the heads were dirty. During backwashing and rinsing, the water should be coming out with force. The pump pressure should even be lower when you return to filtering. Each time I backwash my pump head, the water comes out with extreme force. It has only trickled when something was going wrong. The pump may have been drawing air or the heads were dirty. During backwashing and rinsing, the water should be coming out with force. The pump pressure should even be lower when you return to filtering.
How do we backwash sand filter?
Backwash a sand filter with a multiport valve; # turn off the pump motor # Start by Rrotating the handle on the multiport valve from the FILTER position to the BACKWASH position, Usually in the opposite direction) # Start the pump, Usually there is a clear bubble on the sand filter and you will see dirty water running through it, Wait until this water starts to run clear. otherwise keep an eye on the water exiting if you can until it runs clear. this can take about 2 to 4 minutes. # Shut off pump motor and move multiport valve handle to the RINSE position .Run on rinse for 15 - 30 seconds. once again you can keep an eye on the clear bubble to see the water clear if you have one. # Shut off pump motor again and move multiport valve handle back to the FILTER position # Now start pump again on and take note of the lower pressure. when the pressure gets too high again it is time to backwash once again.
What should you do if after vacuuming your pool the hayward filter will come on but won't circulate backwash or do anything?
Check to see if your water level is below the skimmer line after vaccuming. Without water you can burn the motor up. Can you turn the filter to waste? jsboyles@shentel.net
Where is the water coming from in the blower motor 1998 Chevy pickup?
Heater core leaking?
The window washers are not working no water coming out and no motor sound?
check the fuse first
