It will wear it out sooner and cost you unnecessary money in power but it wont hurt it there are many systems that have pool pumps that have a slow speed with just that in mind.
Running the vehicle with a partially clogged fuel filter. Continuously running it with the tank almost empty.
A bilge pump does not run continuously. If you have one that is running all the time it is not working properly. Running all the time will wear it out.
Your well pump may be running continuously without building pressure due to a potential issue with the pressure switch, a leak in the system, a clogged filter, or a problem with the pump itself. It is important to troubleshoot and address the underlying cause to prevent further damage to the pump and ensure proper functioning of your well system.
As long as the engine is running, the fuel pump is running.
Start with an almost empty tank, (if possible), as running the fuel pump continuously for an extended period of time may overheat and damage the pump. Otherwise follow these instructions, and give the pump a "rest" every few minutes. Disconnect the fuel line anywhere before the fuel regulator, (e.g., @ the fuel filter), turn ignition switch to "on" (not start), and this will allow the pump to run continuously
Your sump pump may be continuously running due to a high water table, a malfunctioning float switch, a clogged discharge pipe, or a faulty check valve. It is important to investigate the cause and address it promptly to prevent damage to your pump and basement.
Your sump pump may be running continuously but not pumping out water due to a clog in the pump or discharge pipe, a malfunctioning float switch, or a problem with the check valve. It is important to troubleshoot and address the issue promptly to prevent potential flooding.
check the filter
Either the fuel filter is clogged or the fuel pump is defective, even if it is a new pump.
Your well pump may be running continuously due to a variety of reasons, such as a leak in the system, a faulty pressure switch, or a drop in the water table. It is important to have a professional inspect and diagnose the issue to prevent further damage and ensure proper functioning of your well system.
Turn the to the RUN position and try to hear the pump running. Be quick because it will shut off when it reaches proper pressure in the line. Can you hear the pump? If yes, check the filter first (it's the least expensive). If no, make the sure pump has power running to it then check the pump.
A sump pump may run continuously due to a malfunctioning float switch, a clogged discharge pipe, or a high water table. It is important to check these components and address any issues promptly to prevent damage to the pump and potential flooding.