No
form_title= Fiberglass Pools form_header= Relax in the water with a fiberglass pool. Do you want a salt water pool?*= () Yes () No What size is your backyard?*= _ [50] What is your budget for a pool?*= _ [50]
no
No!!! Under no circumstances should you drain a fiberglass in-ground pool. Unlike the standard in-ground pool, the fiberglass pool base is unreinforced concrete or other hard surface material that was applied directly to the soil in a thin layer. It is only there to allow the fiberglass to be sprayed on and form a hard shell. The weight of the water is what holds the fiberglass in place. If you drain the pool without refilling it immediately, you will allow external ground pressures and/or ground water to buckle the sides or bottom and you will have the fiberglass completely redone.
NO Fiberglass salt water pools are a great system regardless of where you use them.
There are kits available for fixing fiberglass steps that are pulling away from the pool. You will need to drain the water below the area where you will be working.
If the cracks are in the surface layer of the fiberglass, the problem can be rectified. These "spider" cracks form in the gel coating of the fiberglass, due to pressures that can occur from a pool that was not installed quite level, for instance. These types of cracks aren't structural. If the bubbles are raised, I would call a pool repair service.
salt water will rust, corrode and eat away any metal that does not have a good protective coating on it if there is a scratch or flaw in that coating the rust will start and continue to spread like a cancer unless stopped and taken care of Yes
This can be done anytime, but it is easiest when the liner is being replaced. Lower the water level sufficiently to make the shallow end dry. Sand the gelcoat about halfway down to the fiberglass (about 1/32") using an orbital random sander with a 24grit sanding pad or paper. Don't worry about harming the fiberglass. Use a mouse sander or a Dremel in tight spots like the joining of the riser and step. Wash the steps clean with water and let dry overnight. Wash the steps with solvent, then apply one coating of swimming pool (not marine) gelcoat. When gelcoat is dry with no tackiness, roll-on a second coating. Let cure for 3 full days before covering with water. Enjoy your pool.
Yes, you can use chlorine in a fiberglass pool. It is a common sanitizer for pools and helps to keep the water clean and free of bacteria. Just be sure to follow the manufacturer's guidelines for the proper amount of chlorine to use in your fiberglass pool to prevent damage.
Cobalting is what the black spots on fiberglass pools is called. This occurs when the gel finish on the pool begins to break down. You can remove the old gel coating and apply a new one.
To remove fiberglass coatings from gunite pools, first, drain the pool and clean the surface thoroughly to remove debris and contaminants. Then, use a chemical stripper specifically designed for fiberglass removal, applying it evenly and allowing it to sit as per the manufacturer's instructions. Scrape off the softened fiberglass with a plastic or metal scraper, and finally, rinse the pool surface thoroughly with water to remove any residue. Always wear protective gear and ensure proper ventilation when working with chemical strippers.
it doesn't really matter